Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

metal cutting (FiguRe e)
• Use a finer blade for ferrous metals and a coarse blade for
non-ferrous materials.
• In thin gauge sheet metals it is best to clamp wood to the
underside of the sheet. This will ensure a clean cut without
excess vibration or tearing of metal.
• Avoid forcing cutting blade as this reduces blade life and
causes costly blade breakage.
NOTe:
You should spread a thin film of oil or other coolant
along the line ahead of the saw cut for easier operation and
longer blade life. for cutting aluminum, kerosene is preferred.
pocket cutting - wood only (FiguRe F)
• Measure the surface area to be cut and mark clearly with a
pencil, chalk, or scriber.
• Insert blade in blade clamp and tighten blade clamp securely.
• place blade at desired cutting point and tip the saw
backward until the back edge of the shoe is resting on the
work surface.
• Switch motor on, permitting blade to attain maximum speed.
• Grip handle steadily and begin a slow, deliberate upward swing
with the handle of the saw, plunging the blade into the wood.
• The blade will begin to feed into material. Always be sure
blade is completely through material before continuing with
pocket cut.
NOTe:
IN AReAS wHeRe BlAde VISIBIlITY IS lIMITed, USe THe edGe Of THe
SHOe AS A GUIde.
PrOJecT TiPs
• Cut only with sharp blades; they cut cleaner, faster and put less strain on the motor while cutting.
• when cutting, always ensure that the shoe is resting against the workpiece. This will improve
operator control and minimize vibration.
• for longer blade life, use bi-metal blades. These utilize a carbon steel back welded to high
speed steel teeth making the blade more flexible and less prone to breaking.
Problem
• Unit will not start.
for assistance with your product, visit our website www.blackanddecker.com for the location
of the service center nearest you or call the BlACK & deCKeR help line at 1-800-544-6986.
NoTE: Refer to power Unit instruction manual for troubleshooting solutions regarding operation
of the power Unit.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get inside the tool;
never immerse any part of the tool into a liquid.
IMpORTANT: To assure product SAfeTY and RelIABIlITY, repairs, maintenance and
adjustment (other than those listed in this manual) should be performed by authorized service
centers or other qualified service personnel, always using identical replacement parts.
All manuals and user guides at all-guides.com

TRoUBlEShooTING

Possible Cause
• Attachment is not secured.
5
5
E
f
Possible Solution
• Make certain the attachment is fully
pushed into the power Unit.

Publicidad

Tabla de contenido
loading

Tabla de contenido