Setting Up The Transmitter - Alto Professional STEALTH WIRELESS Guia Del Usuario

Setting Up the Transmitter

1. Use a standard XLR cable or 1/4" (6.35 mm) cable (not included) to connect your mixer or other
audio source to the transmitter's Combo Inputs.
2. Use the included power adapter to connect the transmitter's power connector to your power
source. Press the Power button to turn the transmitter on.
3. Make sure the receiver is powered on and within 200 feet (61 meters) of the transmitter with clear
line of sight.
4. Press the CH button to enter Channel Selection mode. Press once to adjust the Left stereo
channel and press a second time to adjust the Right stereo channel.
5. Press the +/- buttons to cycle through the available channels until you have selected the same
RF channel that the receiver has selected. Wait ten seconds or press another button to exit
channel selection mode.
Important: If you are setting up a system using multiple receiver-transmitter pairs, set up each
receiver one at a time and keep each receiver powered on as you set up additional units. This will
prevent each pair from automatically selecting the same channel.
6. Once the the receiver and transmitter are tuned to the same channel, watch the receiver's AF
indicator and RF indicator to make sure a signal is being received. If you receive interference,
change the receiver and transmitter to another channel until a clean signal comes through.
7. Press the Mono/Stereo button to change the wireless signal that is sent to the receiver to be
either mono or stereo.
8. Press the Vol button to enter volume adjustment mode and use the +/- buttons to adjust the
volume level. When finished, wait five seconds to exit volume adjustment mode.
8