weltico EASYLED Instrucciones De Instalación página 9

Thank you for choosing WELTICO equipment. Please read these instructions which will allow you to get the best use of
our equipment.
12V AC LED PROJECTORS
- Made of ABS / PC
- The installation of this projector requires qualified people.
Use only when immersed in water.
Works only with a 220 Vac/12 Vac toroidal transformer.
IMpORTanT: This manual contains important information on the safety measures to be adopted at the time of
installation and switching on. It is therefore essential that the installer and user must read these instructions carefully
before starting installation and switching on.
IMpORTanT SafETY nOTE: Electrical installations for swimming pools must comply with the requirements standards
NF C 15-100 and regulations in force (domestic mains).
EaSYLED SWIMMInG pOOL pROJECTOR
White or coloured LEDs
TEChnICaL SpECIfICaTIOnS:
LaMpE EaSYLED
6 WhITE LEDs
- Standard input: 12 V AC.
- Lifetime (LED): ~ 25,000 hours.
Model: 1500 lumens (+/ - 10%)
Maximum power requirement: 24W
LaMpE EaSYLED
12 WhITE LEDs
- Standard input: 12 V AC.
- Lifetime (LED): ~ 25,000 hours.
Model: 3000 lumens (+/ - 10%)
Maximum power requirement: 45W
12 COLOuRED LEDS
- Standard input: 12 V AC.
- Lifetime (LED): ~ 25,000 hours.
Model: 1600 lumens (+/ - 10%)
Maximum power requirement: 40W
10 colours/5 continual colour sequences.
- Change colours or sequences (standard) by turning off the power button "ON/OFF».
- Optional: colour or sequence changes using the Monitor-Modulator Receptor KIT with
wireless remote control.
- Remember the bulb colour or pre-defined sequence after switching off the power.
Instructions:
When turned on, the bulb lights up. To change the colour or sequence, proceed by turning off the power button ON/
OFF in manual mode. The procedure requires a power cut of
1 second.
On the first power cut, the bulbs will set to the first fixed colour. At each subsequent cut, the
10 fixed colours will light up, followed by 5 continual sequences until it comes back to the first fixed colour.
A power cut longer than 10 seconds memorises the current sequence or colour, enabling the predefined colour or sequence of
lights
to be restored.
INSTRUCTION MANUAL
Models:
Page : 9