Kobalt KXID 124B-03 Manual Del Usuario página 11

OPERATING INSTRUCTIONS
5. LED Worklight
The LED worklight (F), located on the base of
the impact driver, will illuminate when the trigger
switch is depressed. This provides additional light
on the surface of the workpiece for operation in
lower-light conditions.
The LED worklight will turn off after approximately
10 seconds when the trigger switch is released.
a. The LED worklight will blink rapidly if the
tool has stopped working in order to protect
internal circuits; please wait for the tool to cool
down, at which point it can be started again.
b. The LED worklight will blink slowly to indicate
that the battery charge is very low.
6. Installing and Removing the Belt Clip
a. Align the rib of the belt clip (G) with the hole on
the base of the impact driver.
b. Tighten the screw (H) securely with a Phillips
screwdriver (not included).
c. To remove the belt clip, use a Phillips
screwdriver to loosen the screw holding the
belt clip to the impact driver.
WARNING
• If the sleeve does not return to its original
position, the bit is not correctly installed. Retry
until the bit is properly installed and the sleeve
returns to its original position.
5
F
6
G
11
H