Operation - Meister BAS 108 LIO Traducción De Las Instrucciones De Servicio Originales

5401010-Akku-Bohrs-man.qxd
CAUTION! The specifications on
the power supply must match
the power source. If necessary ask
your local power supplier.
As soon as contact with the power
network is made, both control LEDs will
light up in GREEN.
Put the rechargeable battery into the
charging station. During the charging
process, the two control LEDs will light
up, one in GREEN and the other in RED.
As soon as the charging process is
completed, both control LEDs will light
up in GREEN again.
CAUTION! If a recently used up
battery is inserted and one of the
two LEDs does not light immediately,
remove the battery and start the
charging process again a few minutes
later.
The normal charging time is around
3-5 hours. After this, the charger ensures
constant maintenance of the charge. The
battery is protected from overloading by a
thermal protection mechanism, thus it
can be left in the charger for long periods
of time without damaging the battery. An
even warming of the charger and battery
is normal and does not represent a fault.
A battery with a considerably shortened
operating time indicates that it needs to
be replaced.
Note: The range of the battery is
influenced by the charged state, the
frequency of use, the material being
processed and the level of energy
required to do so.
A new battery only reaches full
performance capability after 5 charge
and discharge cycles.
24.03.2010 11:45 Uhr
All manuals and user guides at all-guides.com
It the range of a freshly charged battery
should drop considerably when
compared to a new one, the battery is
old and should soon be replaced by a
new one. To do this, contact the
specified service station.
The rechargeable battery is protected
by a thermo-protection fuse against
overcharging - nevertheless it should
be withdrawn from the charging unit
on expiry of the charging time. A
constant heating of charging unit and
rechargeable battery during the charging
is normal and does not represent any
malfunction.
an electrical time-switch clock!
8 – Operation
All standard screwdriver bits, bit holders
and drills, up to a diameter of 10 mm
(not in the scope of delivery), can be
clamped in the drill chuck (1) (Fig. 4).
The machine is provided with a quick-
action drill chuck. In this way, you can
replace the accessories in manual
operation rapidly and without drill chuck
keys (Fig. 5).
is always fixed with a left-hand thread
bolt. This is to be loosened in front
through the drill chuck (1) before a
drill chuck change. Left-hand thread
bolts can be loosened through
clockwise rotation only.
The screwdriver bits and drill bits with a
length of 50 mm can also be inserted
directly into the bit receptacle.
Seite 63
TIP! It is recommended additionally
to control the charging process via
The drill chuck of clockwise/
anti-clockwise rotation machines
63