Carton Contents; Functional Description - Porter Cable 884 Manual De Instrucciones

All manuals and user guides at all-guides.com
Contents of the packaging carton include the router, driver/drill, high-capacity
battery pack, advanced diagnostic charger, and an instruction manual.

FUNCTIONAL DESCRIPTION

FOREWORD
Your Porter-Cable Cordless Driver/Drill is designed to drill holes and drive fasteners
in various materials as indicated in the following chart:
SPEED
RANGE MILD STEEL ALUMINUM WOOD SELF-FEED BIT WOOD SCREWS
LOW 3 "
/
8
HIGH 3 "
/
8
SWITCH OPERATION
Squeeze the trigger switch (A) Fig. 1
to start the motor. Release the trigger
switch to stop the motor. As the
trigger is squeezed, the motor speed
increases.
NOTE: You will hear a low volume, high
pitched tone while the switch is in the
variable speed mode. This is normal.
FORWARD/REVERSE
• Make sure that the trigger switch (A) Fig. 1, is in the "OFF" position before
changing direction of rotation.
• Push the button (B) Fig. 1 toward the left side of the drill for FORWARD
(clockwise) rotation.
• Push the button (B) Fig. 1 toward the right side of the drill for REVERSE
(counter clock-wise) rotation.
• Place the button (B) Fig. 1 in the center position to lock the trigger switch in
the "OFF" position.
ELECTRIC BRAKE
When the trigger switch is released, an electric brake automatically engages to
stop the spindle rotation.
INSTALLING AND REMOVING DRILL AND SCREWDRIVER
BITS
1. Always set the reversing button to center (locked "OFF")
position when installing and
removing bits.
2. The three-jaw chuck is designed
for self-centering of the bit. Open
the jaws by turning the outer sleeve
(A) Fig. 2, counter-clockwise, when
viewing the chuck from the bit end.
3. Clean and insert the smooth end
of the bit as far as it will go into the
chuck, or up to the flutes for small
bits.

CARTON CONTENTS

MAXIMUM CAPACITIES
DRILLING
3 "
/
8
3 "
/
8
B
Fig. 2
10
DRIVING
1"
1 "
/
2
A
Fig. 1
B
A
3 "
/
8
#10