Intended Use; Safety Instructions - BGS technic 6932 Guia De Inicio Rapido

TOOLS
1 Retaining bolts
2 Spindle 3/4"x16UNF, drive: outer hexagon 22 mm
3 Puller bridge with holes for retaining bolts
4 Clamping bridge
5 Puller feet, lenght 102 mm
6 Stepped disc, diameter 44.4 / 28.5 mm
7 Stepped disc, diameter 41.2 / 31.7 mm
8 Stepped disc, diameter 38.1 / 28.5 mm
9 Stepped disc, diameter 34.1 / 23.8 mm

INTENDED USE

This puller is used to disassemble the bearings on the differential cage and is suitable for a variety of
motor vehicles and light commercial vehicles. The tool kit includes four stepped discs for different
diameters of bearing stub on the differential cage.

SAFETY INSTRUCTIONS

Read the instructions and safety instructions carefully before starting work.
• Do not use this tool set for other purpose for which it is designed.
• Observe the general safety instructions for garages.
• Keep your work area tidy and clean. Areas or corridors which are untidy increase the risk of
injury.
• Lifting of vehicles only allowed on the special lifting points.
• Before starting the work under a vehicle always ensure that it is adequately supported by axle
stands or ramps. Chock wheels and ensure that the hand brake is firmly applied.
• Always use approved eye protection, especially when working under vehicles.
• Ensure a secure and well-gripped stance during fitting.
• Check the condition of the tool regularly and do not use it if it is damaged.
• Make sure the tool is properly mounted.
• Do not over tighten the spindle or apply excessive force, as this may damage both the tool and
the component.
• The tool is not suitable for impact wrenches. The use of an impact wrench can rupture tool parts
and flying tool fragments can cause injury.
• This manual serves as a brief guide and does not replace a workshop manual. Always refer to
the vehicle-specific service literature, particularly the technical data such as torque values and
instructions for disassembly/assembly, etc.
• Fetten Sie immer die Schraubengewinde, ehe Sie das Werkzeug verwenden.
• Keep children and other unauthorized persons away from the work area.
• Do not let children play with the tool or its packaging and keep this tool out of the reach of
children.
BGS technic KG
Bandwirkerstr. 3
D-42929 Wermelskirchen
Differential Cage Bearing Puller
Tel.: 02196 720480
Fax.: 02196 7204820
mail@bgs-technic.de
BGS 6932
www.bgstechnic.com
© BGS technic KG, Copying and further use not allowed