Operating; Cleaning; Technical Features - TREVIDEA g3ferrari BONJOUR Manual Del Usuario

OPERATING THE UNIT
1. Check that the coffee maker is cold, and then unscrew it by holding the boiler (3) with one hand and
turning the pitcher (2) anticlockwise.
2. Remove the funnel (11) and, to prepare 3 cups of coffee, fill the boiler (3) with fresh water until reaching
the safety valve (10) which is visible inside the boiler, without exceeding it. On the other hand, to prepare
1 cup, fill the boiler (3) with water up to the mark (at 2 centimeters) located below the safety valve (10).
Note: use fresh and soft water. Salty or hard water will weaken the aroma.
WARNING: do not use the coffee maker without water inside the boiler; never use hot water for faster
operation.
3. Insert the funnel filter (11) in the boiler (3). To prepare 1 cups of coffee, also insert the 3 cups adapter
(12) in the funnel filter (11).
4. Fill the funnel filter (11) with ground coffee, without pressing it. Fill it a little at a time to prevent the
coffee from spilling.
5. Distribute the ground coffee uniformly removing coffee from the edge of the filter.
Note: Use good quality, medium-ground coffee, for MOKA coffee makers.
6. Tighten the coffee maker securely, by holding the boiler (3) with one hand and turning the pitcher (2)
clockwise, without pushing on the handle.
7. Rest the coffee maker on the electric base (6) and close the lid (1).
8. Press the on/off switch (8), the pilot lamp (9) will light on.
9. The coffee will start to be released from the tube (13) after a few minutes.
10. When the pitcher (2) is full, mix the coffee before serving.
Note: before using the coffee maker for the first time, all the accessories and the internal circuits should be
washed with hot water. Then make a few batches of coffee to throw away.

CLEANING -

Unplug the unit and wait until the complete cooling down of each part before
starting cleaning operations.
Periodically clean the tube (13). Periodically check the condition of the funnel (11) and the gasket (5): if you
find any signs of tear, you should replace them. Check that the holes in the disk filter (4) are not blocked;
wipe it off with the help of the head of a pin.
Do not wash the coffee maker in the dishwasher. Do not rinse the boiler. Do not immerse the electric base in
water or other liquids and avoid splashing of water reaching the unit. In this case, carefully wipe any part of
the appliance. Do not use solvents or abrasive cleaners to clean the unit, wipe with a soft damp sponge
making sure not to wet the electrical parts.
Drinking water can cause scale deposit in the valve hole (10). The valve can therefore be stuck, resulting in
malfunction and also the unsafety of appliance. To avoid this inconvenience, during normal cleaning
operations, just move the piston that comes out of the safety valve (10). This will keep the valve efficient, will
guarantee safety and will also improve operation of the device.

TECHNICAL FEATURES

•
Power supply: AC 230V, 50/60 Hz. Power 400W
•
Maximum capacity 3 cups - Pilot lamp
•
30 minutes keeping warm function
TROUBLESHOOTING
Problem
No coffee is released
The coffee takes a
long time to be
released
Cause
No water in the boiler
- The coffee used is not right
- The disk filter is blocked
- The coffee has been pressed
Solution
Fill the boiler with fresh water
- Use ground coffee for Moka
- Clean the disk filter as described in the
Cleaning paragraph
- Do not press the ground coffee
11