G5V006; Assembly; Operating The Unit; Cleaning - TREVIDEA g3ferrari Girandolo 40 Manual Del Usuario

DESCRIPTION G5V006
1 Front protection grid
4 Handle
7 Base

ASSEMBLY

Before placing the fan on the ground, assemble the stand on the base of the unit. For wall mounting, follow
the steps below:
- Place the fan choosing the right height so as children cannot reach the unit.
- The fan must be placed at a minimum distance of 20 cm from the ceiling or sidewalls. Do not mount on a
surface subjected to vibration.
- The base (8) must be mounted perpendicular to the wall, the inclination can be set by moving the
inclination joint (5). Buy 2 screws # 8 and 2 plugs according to the size of the screws and the wall
material (brick , concrete, wood , etc ...).
- Take the base (8) and place it on the wall, where you want to place the product.
- Mark the position of the holes on the wall.
- Drill the wall on the signs and insert the plugs into the holes. Tighten the screws. Do not tighten
completely, but leave the heads of the screws 1.6cm out from the wall. Align the holes in the base (8)
with the screws and attach the fan to the wall by inserting the screw heads in the holes.

OPERATING THE UNIT

At the end of the assembly operations, install the unit as following the Safety Information paragraph and
connect the plug to the power outlet. By using the control knob (3), adjust the
rotation speed of the fan and the strength of the ventilation as follow:
- 0: The fan is switched off
- 1: fan is running at low speed
- 2: fan is running at medium speed
- 3: fan is running at the highest speed
- The fan can be adjusted 180° vertically.

CLEANING

Unplug the unit from the power outlet before starting any cleaning operation.
- Do not immerse the unit in water. In any case, avoid splashing water or
other liquids from reaching the motor housing.
- Do not clean with sponges or abrasive cleaners, use a neutral detergent and
a soft cloth dampened with water to clean all the parts.
- Dry the appliance before operating.
- To clean the fan and the inside unit, you can unscrew the front grid (1) as
shown in the Figure aside.

TECHNICAL FEATURES

•
Power supply: AC 230V
•
100% copper winding motor, without aluminum
•
Fan diameter: 40cm
•
180 ° vertically adjustable. 3 operating speeds
•
Suitable for wall mounting. Handle
2 Fan
5 180° inclination joint
8 Wall mounting holes
~
50Hz. Maximum power 55W
3 Three speeds control knob
6 Rear protection grid
9