G40011; Installation; Operating; Filling The Tank - TREVIDEA g3ferrari STIROPIU' Manual Del Usuario

the limestone inside the boiler will not settle on the
walls. Descale once or twice a month to keep the
equipment in good condition.
DESCRIPTION G40011
(A) Steam button
(D) Temperature control knob
(G) Power switch
(J) Power cord and plug
(M) Tank
(P) Power cord storage box

INSTALLATION

Place the ironing system on a stable surface, away from heat sources.
On first use, or after the iron has been unused for long time, it is recommended to expel steam by pushing the
button (A) for about 20 seconds. This allows to eliminate any working or limestone leftovers.
When you turn on the device, it can emit a pumping noise. This is normal: it is the internal pump that pour
water into the boiler.

FILLING THE TANK

- Take the tank handle (O)
- Pull out the container (M)
- Fill the tank with water up to "MAX" sign.
- Replace the container (M) until it snaps.
It is possible to refill the container at all times. If the internal pump makes a long and strong noise, check if
there is water in the container, and fill it immediately to avoid pump damaging.
We recommend the use of demineralized water to prevent excessive fouling (not covered by warranty).
When using the product for the first time or after a descaling operation, plenty of water will be pumped into
the boiler. After pumping, it is recommended to fill the tank (M) for having a better operating time.
OPERATING THE SYSTEM
- Power on the unit by pressing the button (G). The lights (E and K) will switch on.
CAUTION: when the tank control light (K) shuts down, it means that the boiler is ready to produce steam.
During normal operation, the light lights on intermittently.
- Adjust the temperature using the control knob (D) according to the fabric to be ironed (see table at page
7). The plate temperature control light (B) will light up to indicate the iron is heating.
CAUTION: when the light shuts down it means that the plate has reached the desired temperature. During
normal operation, the light comes on intermittently. The emission of the vapor is only possible with
temperatures above ● ●.
Start ironing only when the lights of iron (B) and of boiler (K) are both off.
- For the use of steam, horizontally or vertically, press button (A).
During use the appliance will periodically fill the inner boiler taking water from the container (M).
CAUTION: when using the steam, wait for the complete heating of both the iron and the
boiler. In the beginning, few drops will come out together with the steam. This is normal and
it is due to the heating of the cable connecting the boiler and iron.

TEMPERATURE SETTING

The following table provides a guideline on how to adjust the thermostat according to the international
symbols printed on the clothing labels or according to the type of fabric.
(B) Iron temperature control light
(E) Power light
(H) Steam tube storage box
(K) Control indicator "Steam ready"
(N) Rubber support
(R) Boiler body
(C) Handle
(F) Case for power cord and steam hose
(I) Soleplate
(L) Descaling hole
(O) Handle of boiler
14