Electrical Connection; Appliance Description; Temperature Controller - Beem Waffel-Flipp Manual De Instrucciones

EN
Requirements for the place of use
For safe and trouble-free operation of the
appliance, the place of operation must sat-
isfy the following requirements:
■ Place the appliance on a dry, flat, wa-
terproof and heat-resistant surface.
■ The surface finishes on furniture may
contain substances that can be detri-
mental to the rubber feet of the appli-
ance. If necessary, place a mat under
the feet of the appliance.
■ Do not install the appliance in a hot,
wet or very humid environment.
■ Select a location that does not allow
children to reach the hot surfaces of
the appliance.
■ The mains socket must be easily ac-
cessible and allow fast disconnection
in the event of an emergency.

Electrical connection

For safe and trouble-free operation of the
appliance, the following instructions must
be observed for the electrical connection:
■ Before connecting the appliance,
compare the connection data (voltage
and frequency) on the rating plate with
those of your mains power supply. The
data must correspond in order to avoid
damage to the appliance. If in doubt,
ask your electrical appliance retailer.
■ The mains socket must be protected
by at least a 10 A automatic circuit
breaker.
■ Ensure that the mains cable is undam-
aged and is not laid over hot surfaces
or sharp edges.
BEEM - Elements of Lifestyle
All manuals and user guides at all-guides.com
■
■
(refer to the fold-out page for illustration)
1
2
3
4
5
6
7
8
9
10
11
12
Proceed as follows to set the temperature:
‹
The connecting cable must not be
strained or bent.
The electrical safety of the appliance
is only assured when it is connected
to a properly installed protective earth
(PE) conductor system. Connection to
a mains socket without PE conductor
is forbidden. If in doubt, the electrical
system must be checked by a qualified
electrician. The manufacturer assumes
no liability for injury or damage caused
by a missing or interrupted protective
earth conductor.

Appliance description

Temperature regulator
Temperature indicator light (green),
top
Power indicator light (red)
Lid
Supports
Handle
Temperature indicator light (green),
underside
Hotplates
Base
Clip for vertical position
Locking lever
User manual (not illustrated)

Temperature controller

Turn the temperature regulator (1) to
the desired level:
Symbol Meaning
0 Heating off
Min
lowest temperature
Max highest temperature
Waffel-Flipp
19