Publicidad
Idiomas disponibles
Idiomas disponibles
The assembly of elements, once selected all lengths, place in each half of Ø 13mm front, insert one by one, the tubes of 10mm diameter
x 200mm (EA0120010) in one of the 13mm tube. Once fixed and the first part of an item, enter the next half and secure again screws
DIN 7984 M4X10 and the M4 Insert rivet which is detailed below. Note that the screw head has to be accommodated within the
bigger hole in element.
13mm Ø
SI
The fixing of the LOOP element, each element is using a Hose Clamp 8-12mm (P0100022) the 13 to 10mm diameter.
Measures page 2 are expressed in external lenght , ie, measuring from each end of the tube. Once elements are assembled correctly ,
proceed to put each item on the plate to the boom , which would be the last step assembly . Attach plates to boom as specified below .
Once you have the elements assembled, it's time to mount the plates to the boom and then the elements to the plate.
What we advise is to start with the plates to the boom, if you rise up the antenna in one piece. If you want to raise the elements
once the boom is placed on the mast, we recommend putting the elements to the plates for their best way of the "plate / element" assembly to the
boom.
To add the elements to the plate would have to focus with the help of a tape measure, each element of Ø 13mm, mark in the half with a edding,
and a once centered fix to the plate with the green plastic blocks (EAHYP013) with screws DIN 912 M6X40, as shown in the drawing below .
To place each plate to the boom, are fixed by screws DIN 912 M6X20 and DIN 9021 M6 washer. This plate must be very firm for positioning the
element. The next step would be like the other elements, but considering that the screws use are DIN 912 M6X40 and DIN 985 M6 self-locking
nuts once it is all assembled antenna.
DIN 7984 M4X10
INSERT RIVET M4
HOSE CLAMP 8-12mm Ø
(P01000022)
13mm Ø
DRIVEN ELEMENT
10mm Ø
NO
10mm Ø
6m Plates
DIN 912 6x40mm
DIN 985 M6
DIN 912 6x20mm
DIN 9021 M6
ENGLISH
Publicidad
