Ragalta RWC-120 Manual De Instrucciones página 3

 Never clean parts with flammable fluids. The fumes can create a fire hazard or
explosion.
 Do not store or use gasoline or any other flammable vapors and liquids in the vicinity
of this or any other water dispenser. The fumes can create a fire hazard or explosion
 Do not plug unit into receptacle until you ensure the water tank switch is off.
INSTALLATION GUIDELINES

Remove the exterior and interior packing.

Place your water dispenser on a desk that is strong enough to support the dispenser when
it is fully loaded.

Locate the appliance away from direct sunlight and sources of heat (stove, heater, radiator,
etc.).
Direct sunlight may affect the acrylic coating and heat sources may increase electrical
. consumption Extreme cold ambient temperatures may also cause the appliance not to
perform properly.

Allow 2 inches of space between the water dispenser and the wall which allows proper air
circulation.

Plug the appliance into an exclusive properly installed-grounded wall outlet. Do not under,
any circumstances, cut or remove the third (ground) prong from the power cord. Any
questions concerning power and/or grounding should be directed toward a certified
electrician or an authorized Products Service Center.

This water dispenser is not recommended for outdoor use.

Do not locate the dispenser in area where the temperature may fall below freezing (32º F).

Keep area around dispenser free of dust and dirt.

Keep the reserve supply of water bottles away from excessive heat and light.

Never unplug the water cooler, except for maintenance.
Before Using Your Water Dispenser

Before connecting the appliance to the power source, let it stand upright to approximately 2
hours. This will reduce the possibility of a malfunction in the cooling system from handling
during transportation.

The water dispenser is pre-cleaned at the factory but the reservoir and water lines must be
flushed with fresh water before use as follows.

Keep the unit unplugged.

Fill water tank with tap water full to capacity .Wait for 5 minutes until water settles.

Slide child safety button, then push the hot water faucet until water comes out, and then
stop.
 Proceed to drain the water from the faucets until no more water remains.

Drain any water left in the tank by opening the water drain plug located on the bottom until
it drains completely.

Proceed to close the drain cap. Also make sure both faucets are released completely.

Place the water bottle on the water intake; allow water to stand for approximately one
minute.

Push both water faucets to insure water flows from both faucets, then release both faucets.

Plug dispenser into the electrical outlet.

Turn power switch ON (at the rear).
All manuals and user guides at all-guides.com
3