Grand Hall MFA05ALP Manual De Instrucciones página 17

NOTE about LP Gas Tank Exchange Programs
Ÿ
Many retailers that sell grills offer you the option of
replacing your empty LP Gas tank through an exchange
service. Use only those reputable exchange compa-
nies that inspect, precision fill, test and certify their
tanks. Exchange your tank only for an OPD safety
feature-equipped tank as described in the LP Gas tank
section of this manual.
Ÿ
Always keep new and exchanged LP Gas tanks in an
upright position during use, transit or storage.
Ÿ
Leak test new and exchanged LP Gas tanks BEFORE
connecting one to your grill.
How to Leak Test your LP Gas Tank
For your safety:
Ÿ
All leak tests must be repeated each time your LP Gas
tank is exchanged or refilled.
Ÿ
W hen checking for gas leaks do not smoke.
Ÿ
Do not use an open flame to check for gas leaks.
Ÿ
Your grill must be leak tested outdoors in a well-
ventilated area, away from ignition sources such as
gas fired or electrical appliances. During the leak test,
keep your grill away from open flames or sparks.
Ÿ
Do not use household cleaning agents. Damage to
gas assembly components can result.
Use a clean paintbrush and a 50/50 mild soap and
water solution.
Brush soapy solution onto LP Gas tank in the areas
indicated by the arrows. See diagram.
If growing bubbles appear do not use or move the
LP Gas tank. Call an LP Gas Supplier or your Fire
Department.
WARNING
!
If growing bubbles appear do not use or move
the LP Gas tank. Contact an LP Gas Supplier
or your fire department!
All manuals and user guides at all-guides.com
USE AND CARE INSTRUCTIONS
LP Gas Model only:
Secure a 20lb LP Gas Tank to Gas Grill
!
17
Turn your LP Gas Tank Valve clockwise to the
closed or OFF positon.
Place LP Gas tank into tank hole on Tank Tray.
Install the tank so the Tank Valve faces the rear
right corner of cabinet.
Screw the W ing Bolt in to secure the gas tank.
LP Gas Model only:
Connect Regulator with Hose to your LPG Tank
Turn all Burner Valves to the OFF position.
Inspect the valve connection port and regulator
assembly for damage or debris. Remove any
debris. Never use damaged or plugged equipment.
Connect the regulator assembly to the tank valve
and HAND TIGHTEN nut clockwise to a full stop.
DO NOT use a wrench to tighten because it could
damage the Quick Coupling Nut and result in a
hazardous condition.
Open the tank valve 1/4 to 1/2 (counterclockwise)
and use a soapy water solution to check all
connections for leaks before attempting to light
your grill. See "Checking for LP Gas Leaks". If
a leak is found, turn the tank valve off and do not
use your grill until the leak is repaired.
CAUTION: W hen the appliance is not in use the gas
must be turned off at the tank.
W ing Bolt 5/16"x3"
Qty. 1
Key# S235G0534A
Type 1 connection per
ANSI Z21.58b-2002
Quick
Coupling Nut