DeWalt DC980 Manual De Instrucciones página 29

Forward/reverse slider (fig. E)
• To select forward or reverse rotation, use the
forward/reverse slider (2) as shown (see arrows
on tool).
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
Three-gear selector (fig. F)
Your tool is fitted with a three-gear selector (6) to
vary the speed/torque ratio.
1 low speed/high torque
2 medium speed/medium torque
3 high speed/low torque
For speed rates, refer to the technical data.
Do not change gears at full speed or
during use.
Instructions for use
• Always observe the safety instructions
and applicable regulations.
• Be aware of the location of pipework and
wiring.
• Apply only a gentle pressure to the tool.
Switching on and off (fig. A & E)
• To run the tool, press the variable speed switch
(1). The pressure exerted on the variable speed
switch determines the tool speed.
• To stop the tool, release the switch.
• To lock the tool in the off position, move the
forward/reverse slider (2) to the central position.
Screwdriving (fig. A)
• Select forward or reverse rotation using the slider (2).
• Set the collar (4) to position 1 and begin
screwdriving (low torque).
• If the clutch ratchets too soon, adjust the collar
to increase the torque as required.
Drilling (fig. A)
• Select the drilling mode using the collar (4).
• Select forward rotation.
All manuals and user guides at all-guides.com
Drilling in metal
• Use a cutting lubricant when drilling metals.
Drilling in wood
• Use the appropriate type of drill bit.
Consult your dealer for further information on the
appropriate accessories.
Maintenance
Your D
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
• Unplug the charger before cleaning the housing
• Remove the battery pack before cleaning your
• Keep the ventilation slots clear and regularly
Environment
Rechargeable battery pack
This long life battery pack must be recharged when
it fails to produce sufficient power on jobs which
were easily done before. At the end of its technical
life, discard it with due care for our environment:
• Run the battery pack down completely, then
• NiCd and NiMH cells are recyclable. Take them
The exceptions are cast iron and brass which
should be drilled dry.
WALT Power Tool has been designed to
E
with a soft cloth.
power tool.
clean the housing with a soft cloth.
remove it from the tool.
to your dealer or a local recycling station.
The collected battery packs will be recycled or
disposed of properly.
E N G L I S H
29