Radio Interference; Installation; Important - Euromaid MCG30 Manual Del Propietário

2

Radio Interference

Microwave oven may cause interference to
your radio, TV, or similar equipment. When
interference occurs, it may be eliminated
or reduced by the following procedures.
3

Installation

1. Make sure all the packing materials
are removed from the inside of the
door.
2. Inspect the oven after unpacking for
any visual damage such as:
- Misaligned Door
- Damaged Door
- Dents or Holes in Door Window and
Screen
- Dents in Cavity
- If any of the above are visible, DO
NOT use the oven.
3. This Microwave Oven weighs 19 kg
and must be placed on a horizontal
surface strong enough to support this
weight.
4. The oven must be placed away from
high temperature and steam.
The wires in this mains lead are coloured
in accordance with the following code:
Green-and-yellow
Blue
Brown
As the colours of the wires in the mains
leads of the appliance may not correspond
with the coloured markings identifying the
terminals in your plug, proceed as follows:
All manuals and user guides at all-guides.com

IMPORTANT

: Earth
: Neutral
: Live
5
a. Clean the door and sealing surface of
the oven.
b. Place the radio, TV, etc. as far
away from your microwave oven as
possible.
c. Use a properly installed antenna for
your radio, TV, etc. to get a strong
signal reception.
5. DO NOT place anything on top of the
oven.
6. DO NOT remove the turn -table drive
shaft.
7. As with any appliance, close
supervision is necessary when used
by children.
WARNING - THIS APPLIANCE MUST
BE EARTHED.
1. The plug socket should be within
easy reach of the power cord
2. This oven requires 1.5 KVA for
its input consultation with service
engineer is suggested when installing
the oven.
CAUTION: This oven is protected
internally by ac 250V, 10 Amp Fuse.
The wire which is coloured green-
and-yellow must be connected to the
terminal in the plug which is marked with
the letter E or by the earth symbol
coloured green of green-and-yellow.
The wire which is coloured blue must be
connected to the terminal which is marked
with the letter N or coloured black.
The wire which is coloured brown must
be connected to the terminal which is
marked with the letter L or coloured red.
EN