Publicidad
All manuals and user guides at all-guides.com
EN
This manual contains important information that should
be kept for future reference.
Self-assembly.
Warning! Keep children away from the assembly area.
Leave the plastic bags out their reach. The small parts
pose a choking hazard.
Materials
Structure: chipboard oak veneer, clear matt lacquer.
Ladder and support: steel.
Assembly Instructions
In order not to lose components, do not throw the pack-
aging before completing the full assembly.
Before beginning assembly, identify all the components
using the manual.
This product must be assembled by an adult.
Plan to assemble the product as close as possible to
where it will be installed.
Assemble on a clean, flat surface.
Do not use an electric screwdriver.
The product cannot be assembled more than one time.
Warning! Before drilling, make sure that no pipes or
cables will be present in the drilling area. Fix the product
to the wall to ensure its stability. Use the type of screws
and wall plugs for the supporting material.
With time, the bindings can lose their effectiveness.
Regularly check the tightening of screws. If necessary
tighten.
To assemble the extension, remove the right side panel
(7), shelves (3), the sliding support (11), the slide (12) and
the tip of finish (10). Then go to step 15.
Recommendations for use
This product is designed for indoor use only.
Do not climb the product.
Do not overload shelves.
Check the proper assembly before each use.
The wood-based products, particle board, painted, var-
nished and / or lacquers may emit an odor when opened.
This smell disappears after a few weeks if the room is
properly ventilated.
Camus – 12/2018
Maintenance
Part(s) of wood
Remove dust regularly with a dry cloth.
Clean with a soft, damp cloth. Then wipe with a clean
dry cloth.
Wipe up spills immediately with a clean, dry cloth.
To prevent scratching, do not use a sponge or recurrent
grains detergent.
Do not use abrasive products.
The use of special products for the wood is not neces-
sary or recommended.
Do not place the product near a heat source (radiator,
fireplace ...) nor a moisture source. Heat and humidity
may damage the product.
In order not to damage the surface, it is recommended
not to deposit hot items Wet directly.
Clean with movements in the direction of the wood
fibers.
Clear scratches with a cloth soaked in red polish.
Metal components
Remove dust regularly with a dry cloth.
Clean metal parts with a soft cloth dampened with
neutral pH detergent. Then wipe with a dry cloth to
prevent spotting.
Clean chrome surfaces, stainless steel, brass or iron
with specialized products. Always carefully follow the
instructions for use accompanying maintenance prod-
ucts.
Do not use solvent.
Do not oil the metal.
Do not use abrasives.
Keep the label with lot number, it may be useful
in case of complaint.
If you have any comments or suggestions regarding
this product, assembly instructions or service received,
please enquire at your nearest store or contact us on
our website at: www.habitat.eu or write to this address:
HABITAT FRANCE SERVICE CLIENT-42/44 RUE DU
FAUBOURG ST ANTOINE 75012 PARIS-FRANCE
1
Publicidad
