FALMEC quasar Manual Del Usuario página 15

MAINTENANCE
Before cleaning or carrying out maintenance operations, disconnect the
equipment by removing the plug or switching of the main switch.
Do not use detergents containing abrasive, acidic or corrosive substances
or abrasive cloths.
Regular maintenance guarantees proper operation and performance over time.
Special attention is to be paid to the metal anti-grease ilters and active carbon ilters: fre-
quent cleaning of the ilters and their supports ensures that no lammable grease is accu-
mulated.
CLEANING OF EXTERNAL SURFACES
You are advised to clean the external surfaces of the hood at least once every 15 days to
prevent oily substances and grease from sticking to them. To clean the brushed stainless
steel hood, the Manufacturer recommends using ''Magic Steel'' wipes. Alternatively, it can
be cleaned using a damp cloth, slightly moistened with neutral, liquid detergent or dena-
tured alcohol. Finish of cleaning by rinsing well and drying with soft cloths.
Do not use too much water next to the push button control panel and
lighting devices in order to prevent humidity from reaching electronic
parts.
The glass panels can only be cleaned with speciic, non-corrosive or non-abrasive deter-
gents using a soft cloth.
The Manufacturer declines all responsibility for failure to comply with these instructions.
CLEANING OF INTERNAL SURFACES
It is forbidden to clean electrical parts, or parts related to the motor inside
the hood, with liquids or solvents.
For the internal metal parts, see the previous paragraph.
METAL ANTI-GREASE FILTERS
It is advised to frequently was the metal ilters (at least once a month) leaving them to
soak in boiling water and washing up liquid for 1 hour, taking care not to bend them.
Do not use corrosive, acid or alkaline detergents.
Rinse them well and wait for them to be completely dry before reassembling them. Washing
in a dishwasher is permitted, however, it may cause the ilter material to darken: to reduce
the possibility of this problem from happening, use low-temperature washes (55°C max.).
To extract and insert the metal anti-grease ilters see the assembly instructions.
ACTIVE CARBON FILTERS
These ilters retain the odours in the air that passes through them. The puriied air is recircu-
lated into the environment.
The active carbon ilters must be replaced on average every 3-4 months under normal con-
ditions of use.
LIGHTING
The range hood is equipped with high eiciencyа low consumption яшч spotlights with
extremely long duration under normal use conditions.
Should the LED spotlight need to be replaced, proceed as shown in the igure.
1
2
All manuals and user guides at all-guides.com
3
12V
GREASE DRIP TRAy
It is recommended to empty out the drip tray every 15 days and to wash it with boiling hot
water and dish detergent. Do not use corrosive, acid or alkaline detergents. Rinse it well and
wait for it to be completely dry before reassembling it.
To remove the grease drip tray, (see igure).
2
1
DISPOSAL AFTER END OF USEFUL LIFE
The crossed-out wheeled bin symbol on the appliance means that the product
is wEEE, i.e. ''Waste electrical and electronic equipment'' , accordingly it must
not be disposed of with unsorted waste (i.e. with ''mixed household waste''),
but it must be disposed of separately so that it can undergo speciic operations
for its re-use, or a speciic treatment, to remove and safely dispose of any substances that
may be harmful to the environment and remove the raw materials that can be recycled.
Proper disposal of these products contributes to saving valuable resources and avoid poten-
tial negative efects on personal health and the environment, which may be caused by inap-
propriate disposal of waste.
You are kindly asked to contact your local authorities for further information regarding the
designated waste collection points nearest to you. Penalties for improper disposal of such
waste can be applied in compliance with national regulations.
INFORMATION ON DISPOSAL IN EUROPEAN UNION COUNTRIES
The EU WEEE Directive was implemented diferently in each country, accordingly, if you wish
to dispose of this appliance we suggest contacting your local authorities or dealer to ind
out what the correct method of disposal is.
INFORMATION ON DISPOSAL IN NON-EUROPEAN UNION COUNTRIES
The crossed-out wheeled bin symbol is only valid in the European Union: if you wish to
dispose of this appliance in other countries, we suggest contacting your local authorities or
dealer to ind out what the correct method of disposal is.
wARNING!
The Manufacturer reserves the right to make changes to the equipment at any time and
without prior notice. Printing, translation and reproduction, even partial, of this manual are
bound by the Manufacturer's authorisation.
Technical information, graphic representations and speciications in this manual are for in-
formation purposes and cannot be divulged.
This manual is written in Italian. The Manufacturer is not responsible for any transcription
or translation errors.
15
3