Orbegozo EV 3500 Manual De Instrucciones página 20

EV 3500
3. Close lid by pressing down on both sides until two ''click'' sound heard.
4. To begin the vacuum process, press the ''VACUUM&SEAL'' button. The unit will continue to vacuum and
then seal once air has been removed.
5. Once the indicator light turns off, press the release buttons on both sides of the machine to take out the
bag.
How to Use the Pulse Vacuum Button (PULSE VAC)
Since the pressure under the normal vacuum function is set to be high, sometimes it is easy to destroy
some delicate items by high pressure in the vacuum bags. In this case, you can use the ''PULSE'' vacuum
function to control the vacuum time and pressure, and prevent crushing delicate items. When packing some
juicy foods, you can also use this function and prevent liquid being sucked out.
1. Place the item(s) to be sealed into the pre-cut or custom sized bag. Leave at least 2 inches between the
contents and the top of the bag to allow for bag contraction.
2. Open lid and place the open end of the bag down into the vacuum chamber.
3. Close lid by pressing down on both sides.
4. Press the ''PULSE'' button continually, till it reaches the pressure that you want. You can watch the
vacuum bag to decide the pressure. During this process, you can stop vacuum by stop pressing this button,
and press it again to vacuum again.
5. When the pressure reaches what it needs, press ''SEAL ONLY'' button to start sealing.
6. Once the indicator light turns off, press the release buttons on both sides of the machine and take out
the bag.
How to Vacuum Canisters
NOTE : Canister is not included.
1. Connect the vacuum sealer and the vacuum canister using the 2 adapters and tube.
2. Place the product you wish to vacuum pack in the canister. Place the lid on top of the canister and close
it using the side fasteners. Select the "Vacuum" position of the canister valve.
3. Connect the vacuum sealer and the canister via the connecting gasket. You must connect one of the
ends to the canister valve and the other end to the accessory port of the machine.
4. Lower the lid of the machine and press the sides to secure it, the system is properly closed when you
hear a "click" on each side. If you wish to open the upper lid once it has been closed, press each side
again and gently pull the lid up.
5. To start the vacuum process, press the "VACUUM&SEAL" button.
6. This model of vacuum sealer is designed to operate in automatic mode. The machine is equipped with a
vacuum measurement sensor, which stops the vacuum process once the vacuum level is reached within
the canister. To cancel the vacuum process, press the "VACUUM&SEAL" button again.
7. Once the vacuum process is complete, the machine stops automatically. Select the "CLOSE" position of
the canister valve and disconnect the connector gasket from the machine.
20