Using Your Digital Picture Frame - TYPHOON 20115545 Manual Del Usuario

USING YOUR DIGITAL PICTURE FRAME

Step 1: Mount the bracket for tabletop display. Insert the contact points of the bracket into the
holes on the back, and push it forward until it is fixed.
(for horizontal view)
Step 2: Connect the AC adapter to an electronic socket and the DC IN port of the device.
Step 3: Insert a memory card (with the card's electrical contacts towards the front of the unit)
or USB flash drive in the Digital Picture Frame. A slide show should begin automatically.
Step 4: In the slide show mode, you can:
Press the. > button to display the previous or next picture.
Repeatedly press the Rotate button to change time interval between slides.
Repeatedly press the MODE button to cycle through 3 display modes – Pan Scan, Fill
and Original
Press the u button to stop slide show.
Step 5: Briefly press the ? button to stop the slide show and enter the Single Show mode. A
tool bar will appear at the top right corner of the screen, which indicates functions that you
can use at the moment. The current photo will remain on the screen until the button is pres-
sed again, at which time the slide show will resume.
In the Single Show mode, you can:
Press the . > button to display the previous or next picture.
Press the Rotate button to rotate the current picture clockwise: 90°? 180° ? 270°.
Press the MODE button to cycle through 3 display modes –Pan Scan, Fill and Original.
Press the u button to start slide show.
All specifications and information are subject to changes without further notice
Digital Photo Frame
Article No.: 20115545
(for vertical view )
9