Troubleshooting - Hayward MAGIC CLEAN Manual Del Propietário

Above-Ground Automatic Pool Cleaner

Troubleshooting

Problem
Slow/no forward movement
Cleaners movement is fast and erratic
Cleaner sticks at ladder or wall
If the cleaner appears to be stuck or "hung up" at the wall, ladder, or other obstruction, or anywhere else in the pool, and does not return to
normal operation within a minute or so, turn the filter system OFF. Remove the cleaner from your pool. Check for blockages or any other
obvious problems. Check the Bumper Ring for free rotation. Check filter system for water flow and re-install the cleaner. If the cleaner is
getting stuck, contact your Hayward dealer. Under no conditions should the cleaner remain in the pool connected to the filter system if
the problem of getting stuck or "hung up" is not corrected.
To better serve you, please have the following information available if you call Hayward's Technical Service
Department at (33) 825 000 549 (France):
1) The purchase date of your cleaner.
2) The serial number (located on the bottom) of your cleaner.
Cause
Lack of/improper water flow through cleaner
Partial blockage of cleaner throat
Worn shoes
Worn wings
Remove AEV512A
Improper vacuum
Worn shoes
Hose too short
Stuck on ladder
Steering failure
20
_______________________________
Solution
Clean In-Line Leaf Canister
Clean Hair and Lint Pot
Clean Filter System
Clear blockage
Replace shoes
Replace wings
Turn off filter and turn cleaner upside down.
Insert a small screwdriver in the notch at the
rear of the opening. Using a prying motion,
remove the throat.
It may be necessary to purchase an
AEV096P, "In-Line" vacuum gauge from
your Hayward dealer to verify performance
of your system.
Replace shoes
Add additional hose per installation
instructions
Remove ladder or install a Hayward
AEXW100 Ladder Bumper
Check and clean rear screen
Check to see if cone gear rotates smoothly in
both directions