Maintenance And Service Instructions; Cleaning; Repair Service; Warranty - stayer PH82 Manual De Instrucciones

– Guide the machine over the surface to be planed (3) with
even feed.
Beveling Edges (see figure H)
The V-grooves 7 in the front planer base plate allow quick
and easy beveling of workpiece edges. Depending on
required bevel width, use the corresponding V-groove. For
this, place the planer with the V-groove onto the edge of the
workpiece and guide it along the edge.
Slot used
None
Small
Medium
Large
Planing with Parallel/Beveling Guide (see figures D–F)
Mount the parallel guide 17 to the machine using the
corresponding fastening bolt 20. Depending on the
application, mount the rebating depth stop 24 with fastening
bolt 23 to the machine.
Loosen the locking nut 19 and adjust the requested
rebating width on the scale 18. Tighten the locking nut 19
again.
Adjust the requested rebating depth accordingly with the
rebating depth stop 24.Carry out the planing procedure
several times until the requested rebating depth is reached.
Guide the planer applying sideward supporting pressure.

5. Maintenance and service instructions

Before any work on the machine itself, pull the mains
plug.
For safe and proper working, always keep the machine
and ventilation slots clean.

5.1 Cleaning

If the machine should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an after-sales service centre for STAYER
power tools.

5.2 Repair service

Our after-sales service responds to your questions
concerning maintenance and repair of your product as well
as spare parts. Exploded views and information on spare
parts can also be found under:
info@grupostayer.com
Our customer consultants answer your questions
concerning best buy, application and adjustment of
products and accessories.
ENGLISH
11

5.3 Warranty

Warranty card
accompanies this equipment, you should find the warranty
card. You should fill out the card completely and return to
vendor with a copy of purchasing receipt or invoice and you
should receive a receipt.
Note: If you cannot find the warranty card within the
documentation, you must ask for it through your supplier.
The warranty is limited only to manufacturing defects and
expire if pieces have been removed or manipulated or
repaired other than the manufacturer.
measure a (mm)
0 - 2.5

5.4 Disposal and recycling

1.0 - 4.5
2.0 - 5.0
2.5 - 6.0
The machine, accessories and packaging should be sorted
for environmental-friendly recycling.
Only for EC countries:
Subject to change without notice.

6. Regulations

6.1 Technical Data

P
R
Pmax = Maximum depth
Ac
kg
L
L
L
The values given are valid for nominal voltages [U] 230/240 V ~
50/60 Hz - 110/120 V ~ 60Hz. For lower voltage and models for
specific countries, these values can vary. Please observe the
article number on the type plate of your machine. The trade
names of the individual machines may vary.
Noise/Vibration Information
Measured sound values determined according to EN 60745.
Typically the A-weighted noise levels of the product are:
Refer to data table
(
11
Included in the documentation that
Do not dispose of power tools into household
waste! According the European Guideline
2002/96/EC for Waste Electrical and Electronic
Equipment and its implementation into national
right, power tools that are no longer usable must
be collected separately and disposed of in an
environmentally correct manner.
= Rated power input
1
= Load speed
1
= Working width, max
= weight
= Protection class
= Depth stop for recesses
= Length work surface
= Sound power level
WA
= Sound pressure level
A
P
= Vibration
). Uncertainty K =3 dB.