Replacing The Bulb - Mychanic 52601 Instrucciones Operativas

Luz de trabajo con trípode
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

REPLACING THE BULB

Always make sure the unit is in the OFF position and
unplugged when replacing the bulb.
If the bulb feels hot after use, allow it to cool down
or wear insulated gloves before removing to avoid risk
of burn injury.
Top housing around the bulb unscrews from the base
just below the MYCHANIC® logo.
Remove bulb carefully by unscrewing counter-clock
wise from grooves.
Replace with E26 or E27 type replacement bulb,
screwing in clockwise.
Do not tighten too much as this will make the bulb
difficult to remove.
Replace the protective cover by screwing the base
unit back into the housing.
SPECS
Works with class I appliance extension cords

Publicidad

Tabla de contenido
loading

Tabla de contenido