Mitsubishi Electric VL-50S2-E Instrucciones De Operación página 9

Reassembly and checking after
maintenance
Mount the filter and Lossnay Core by the
opposite of the removal procedure.
Caution
- After maintenance, reattach parts securely.
- Injury could result if the unit falls.
(1) Mount the Lossnay Core.
1) Check the orientation of the "Insert" and "Fan
side" markings on Lossnay Core.
2) Insert the Lossnay Core guide along the rail
of the main unit.
3) Push Lossnay Core deeply until the flange
and packing of Lossnay Core make contact.
Rail
Lossnay Core
(2) Mount the outside air filter. (See page
9.)
- Place the outside air filter into the filter frame
and mount it in the main unit. (Do not confuse
the top and bottom.)
All manuals and user guides at all-guides.com
(3) Mount the Exhaust air filter
(4) Close the panel.
Guide
(5) Turn on the circuit breaker or, for
(6) Turn the power on.
Marking
(7) After reassembly, check the
Cleaning the panel/main unit
Eng-9
Exhaust air filter
Main unit catch
Outside air
filter
- Press the panel horizontally against the main
unit.
Panel
the VL-50S -E, plug the power plug
2
into the wall outlet.
following.
- Are the filters and the panel attached securely?
- Is the unit making no strange noises?
- Is the unit blowing air? (Be sure to check the
unit while it is running. Make sure that the
shutter is open.)
If the panel or main unit becomes dirty, wipe it
with a well-wrung cloth soaked in a solution of
neutral detergent and lukewarm water (40°C or
less), then wipe it with a clean cloth to remove
any traces of detergent.
Note
- Use of any of the following solvents in
maintenance may warp, weaken or discolor
Lossnay components.
- Paint thinner, alcohol, benzene, gasoline,
kerosene, aerosol sprays, alkaline cleaners,
chemical wipes, or abrasive-containing
detergents, such as cleansers
- Clean any dust off of the plug. (VL-50S
only)
Outside air filter
Filter frame
-E
2