Control Pads On The Dehumidifier; Indicator Lights; Control Pads - HTW X5WE Manual De Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONTROL PADS ON THE DEHUMIDIFIER

The control panel of the dehumidifier you purchased may be look like one of the following:
6 6
7 7
8 8

Indicator lights

Power on indicator light(green)
1 1
Low fan speed indicator light(green)
2 2
Bucket full indicator light(red)
3 3
Display
4 4
Shows the set % humidity level or auto start/stip time
(0-24) while setting, then shows the actual(+5% accuracy)
room % humidity level.
Error Codes:
AS- Humidity module sensor error--Unplug the unit and
plug it back in. If error repeats, call for service.
ES- Tube Temperature sensor error-- Unplug the unit and
plug it back in. If error repeats, call for service.
EC-Refrigerant leakage detection-- With this new technology,
the display area will appear EC when the unit detects
refrigerant leakage ,call for service.
Protection Code:
P2- Bucket is full or bucket is not in the right position--
Empty the bucket and replace in the right position.
Auto defrost operation on indicator light(green)
5 5
Timer on indicator light(green)
6 6
7 7
Continuous operation on indicator light(green)
5 5
9 9
1 1
4 4
3 3
10 10
3 3
12 12

Control pads

Continue Pad
8 8
Select for the dehumidifier to operate
continuously for maximum dehumidification
until the bucket is full. The Humidity set
control pads cannot be used when
Continuous operation is on.Press this pad
again to cancel Continuous operation.
9 9
TIMER Pad
Press to initiate the Auto start or Auto stop
feature, in conjuction with the
10 10
UP(
)/DOWN(
Humidity Set Control Pads
The humidity level can be set within a range of
35%RH(Relative Humidity) to 85%RH(Relative
Humidity) in 5% increments.
For drier air, press the
percent value(%).
For damper air, press the
percent value(%).
TIMER Set Control Pads
Use the Up/Down pads to set the Auto start or
Auto stop time from 0.0 to 24.
11 11
SILENT Pad
Control the fan speed. Press to select either High
or Low fan speed. Set the fan control to High for
maximum moisture removal. When the humidity
has been reduced and quiet operation is
preferred, set the fan control to Low.
12 12
POWER Pad
Press to turn the dehumidifier on and off.
4
2 2
1 1
11 11
12 12
Control panel(1)
Control panel(2)
and
pads.
) Pads
pad and set to a lower
pad and set a higher

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Htwdb10x5weHtwdb12x5we

Tabla de contenido