Error
Cause
message
Motor not
Er06
connected
The controller has
Er07
no receive signal.
Er13
Short-circuit
Overload
Er14
short-circuit
Notes
•
If the computer display does not show any values, thoroughly check all plug
connections for proper contact.
•
The calorie consumption values (metabolic rate) the computer calculates and
displays are intended as a rough guide, and offer the user (of medium height on
medium resistance setting) the opportunity to compare training sessions. The
values may vary from the actual, medically accurate metabolic rate.
•
This computer was tested according to applicable EMC standards. Nevertheless,
the display may malfunction, especially due to electrostatic discharge. This may
result in unwanted reset or incorrect display of values. Should this happen, you
need only restart the computer (turn it off and back on).
SP-TM-1006-IM-V02-INT.indb 35
Troubleshooting and additional measures
1. Check if the motor cable is loose.
2. Check or replace the motor.
3. Check or replace the controller.
- Please contact our customer service.
1. Check if the communication cable is loose,
detached or damaged.
2. Check or replace the display.
3. Check or replace the controller.
1. Check if the product has a strong interfering
signal.
2. Check or replace the controller.
- Please contact our customer service.
1. Check if there is a foreign object in the
controller's outlet connection.
2. Check or replace the motor.
- Please contact our customer service.
35
4/12/2021 4:31:42 PM