REV 0071 Manual Del Usuario página 8

Read this manual carefully before using this product and check whether there are any damaged parts. The
product has not to be installed in case of damages. Keep this product out of reach of children or any
unauthorized persons. At the end of its lifetime, dispose of the product correctly. Electronic components
have to be disposed of as no standard landfill. This product has been developed according to the latest
technology. You are obliged to install it according to the valid regulations or to have it installed by a qualified
expert. The entire manual has to be followed when installing and using this product. This manual is subject to
technical changes.
The packaging includes:
Halogen floodlight projector 150W or 500W or 1000W
Suitable bulb
Installation
1. Eliminate any voltage and check whether there is really
no voltage left.
2. Pull the cable through the sealing opening. Check carefully
whether the sealing opening is correct so that the
device will be splash proof.
3. Installation according to picture attached.
4. Check carefully whether the pull relief works
properly and use the pull relief in an appropriate manner.
5. Fix the cap horizontally and screw it together so that
the device will be splash proof.
How to use the halogen floodlight projector
Installation of the bulb
1. Make sure that the projector is not connected to the power network.
2. Remove the upper screw from the projector's casing and remove the front glass.
3. Take the bulb out of its packaging. Do not touch the bulb with your bare hand. Use a towel to fix the
bulb into the fitting. First press one side of the fitting against the metal pin and shift the pin backwards
so that you can press the other side of the bulb against the metal pin.
4. After changing the light bulb, please pay attention to the correct positioning of the seal.
5. Fix the front glass with the screw.
A.
Assembling instruction
min. 95°
Halogen floodlight projector
B.
1.
m n. 2 i
2.
00 m m
max. 175°
L
N
green/yellow
C.
GB