The First Wash Cycle; Technical Data; Electrical Connections; Water Connections - Hotpoint Ariston FDG 8640 Instrucciones De Uso

Connecting the drain hose
! We advise against the use of hose extensions;
if it is absolutely necessary, the extension must
have the same diameter as the original hose
and must not exceed 150 cm in length.

Electrical connections

Before plugging the appliance into the
electricity socket, make sure that:
• the socket is earthed and complies with all
applicable laws;
• the socket is able to withstand the
maximum power load of the appliance as
indicated in the Technical data table (see
opposite);
• the power supply voltage falls within the
values indicated in the Technical data table
(see opposite);
• the socket is compatible with the plug of the
washer-dryer. If this is not the case, replace
the socket or the plug.
! The washer-dryer must not be installed
outdoors, even in covered areas. It is extremely
dangerous to leave the appliance exposed to
rain, storms and other weather conditions.
! When the washer-dryer has been installed, the
electricity socket must remain within easy reach.
! Do not use extension cords or multiple sockets.
! The cable should not be bent or compressed.
All manuals and user guides at all-guides.com
Connect the drain
hose, without bending
it, to a drain duct or
a wall drain situated
between 65 and 100
cm from the floor;
alternatively, placed
it over the edge
of a basin, sink or
tub, fastening the
duct supplied to
the tap (see figure).
The free end of the
hose should not be
underwater.
! The power supply cable must only be
replaced by authorised technicians.
Warning! The company shall not be held
responsible in the event that these standards
are not observed.

The first wash cycle

Once the appliance has been installed, and
before you use it for the first time, run a wash
cycle with detergent and no laundry, using
wash cycle auto clean (see "Cleaning the
washer-dryer).

Technical data

FDG 8640
Model
width 59.5 cm
Dimensions height 85 cm
depth 60,5 cm
from 1 to 8 kg for the wash
programme
Capacity
from 1 to 6 kg for the drying
programme
please refer to the technical
Electrical
connections data plate fixed to the machine
maximum pressure
1 MPa (10 bar)
Water con-
minimum pressure
nections
0.05 MPa (0.5 bar)
drum capacity 62 litres
up to 1400 rotations per
Spin speed
minute
Wash: programme 4; tem-
perature 60°C; using a load
of 8 kg.
Energy ra- Drying: the smaller load
ted (2kg) must be dried by
programmes selecting the "A1" (IRON)
according to dryness level. The load must
regulation consist of 2 sheets, 1 pil-
lowcase and 1 hand towel;
EN 50229
the remainder of the load must
be dried by selecting the "A4"
(EXTRA) dryness level.
This appliance conforms to
the following EC Directives:
- 2004/108/EC (Electromagne-
tic Compatibility)
- 2006/95/EC (Low Voltage)
- 2012/19/EU
GB
3