Deleting Measurements From The Memory - EKS Professional Vision Plus 0300 Manual De Usuario

8
Recalling stored results
a. Press the MEM button in clock mode to display the stored
results. The current user number will blink and the results in this
user number will be displayed. Fig. 12.
Press the START button to change to a different user number.
Confirm your selection by pressing the MEM button. The
current user can also be confirmed automatically after 5 seconds
with no operation.
b. After selecting the user number, the
LCD will display the average value of the
last three results for this user, Fig. 13.
(If no results are stored, the LCD will show
0. Fig. 14)
c. After 2 seconds, the most recent result will
be displayed with date and time. Irregular
heartbeat symbol (if any) and the blood
pressure classification indicator will blink
at the same time. Fig. 15
Press the MEM button again to review the
next result. In this way, by pressing the
MEM button, the previous measurements
are displayed. The monitor will turn off
automatically after 1 minute of no
operation.
9
Deleting measurements from
the memory
While any stored result shows in the
display, press and hold the MEM button for
3 seconds and all results for that user will
be deleted. There are 3 beeps and the LCD
shows 2 lines and then 00 in the memory
section.
Fig. 16 & Fig. 17. Press the START button to
turn off the monitor.
All manuals and user guides at all-guides.com
7
mmHg
Fig.13
mmHg
Fig. 15
Fig.16
Fig.12
mmHg
Fig.14
mmHg
Fig.17