Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
1. Disconnect air hose.
2. Use the spanner to take apart the head as fig. 1.
3. Use the spanner to take apart the part as fig. 2.
4. Clean all the parts and inside of the head as fig. 3.
5. Apply lubricating oil as fig. 4.
6. Check the length as fig. 5.
7. Re-assemble the Head of the Riveter by following the disassembly procedure in reverse.
Fig.1
WARNINGS
1. Never use the tool in potentially explosive atmospheres.
2. Keep your body in well balanced position and always wear gloves to reduce the risk of crushing
caused by torque between a reaction bar and work-piece.
3. Unexpected tool movement due to reaction forces or breakage of inserted tool or reaction bar may
cause injuries.
4. Prevent long hair or loose clothing from drawing in while operating the tool. You may get the risk
of being injured if the handkerchief, necktie etc. are not kept away from the running tool.
5. The noise emission (sound pressure level) at the workplace may exceed the normal standard ---
usually 85 dB(A). In this case, a quality ear protector should be used.
6. Unexpected direction of inserted tool movement could case a hazardous situation.
7. Slip / Trip / Fall is a major cause of serious injury or even death. Be aware of excess hose left on
your walking way or on the working surface and be aware of the whipping air hose too.
8. Excessive high air pressure and too much free rotation may speed up the wear of the tool and
may cause dangerous situation.
9. Continuous operation and bad working condition will injure hands. Once hand numbs or aches,
operator shall stop the tool for a while for relaxing and re-start the work after recovery. Operator
shall immediately see a doctor if such a serious symptom occurs.
10. Never change the inner construction and design, which may cause a danger in operation.
SW-Stahl und Werkzeugvertriebs GmbH
L
e
v
e
k r
u
s
r e
t S
a r
s
s
e
6
5
D
4 -
2
8
9
7
R
e
m
s
c
h
e
d i
Fig.2
Fig.4
Tel. +49 (0) 2191 / 46438-0
F
ax +49 (0) 2191 / 46438-40
- E
M
a
: l i
n i
o f
@
s
w
s
a t
l h
d .
e
Fig.3
X = 71 mm
Fig.4
Publicidad
Tabla de contenido
