Operation - Hart HLST01 Manual Del Operador

ASSEMBLY
WARNING:
To prevent accidental starting that could cause serious
personal injury, always remove the battery pack from the
product when assembling parts.
TOOLS NEEDED
See Figure 2.
The following tool (not included) is needed for assembly:
 Phillips Screwdriver
INSTALLING THE FRONT HANDLE
See Figure 3.
 Loosen and remove the wing nut and bolt from the
h andle.
 Install the handle on the power head shaft at the location
indicated by the label on the shaft.
 Adjust handle up or down, if necessary, to desired
o perating position.
 Reinstall the bolt and wing nut. Tighten wing nut to
s ecure.
CONNECTING THE POWER HEAD SHAFT AND
TRIMMER SHAFT
See Figure 4.
 Align the two indentations in the trimmer shaft with the
screws in the power head shaft. Insert the trimmer shaft
into the power head shaft.
 Push the two sections together until the trimmer shaft
stops.
CAUTION:
Be careful when sliding the two shafts together to avoid
pinching your hands or fingers.

OPERATION

WARNING:
Do not allow familiarity with products to make you care-
less. Remember that a careless fraction of a second is
sufficient to inflict serious injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1. Failure to do so could result in
objects being thrown into your eyes and other possible
serious injuries.
 Using a Phillips head screwdriver, turn each of the two
screws until securely tightened.
WARNING:
Be certain the shafts are locked into place before oper-
ating string trimmer; check it periodically for tightness
during use to avoid possible disconnection of shafts,
which could result in serious personal injury.
WARNING:
This string trimmer is designed to use only the provided
trimmer shaft and string head. It is not capable of using
other attachments or cutting heads. Attempting to use
other attachments or cutting heads could result in seri-
ous personal injury.
ATTACHING GRASS DEFLECTOR
See Figures 5 - 6.
WARNING:
The line cut-off blade on the grass deflector is sharp.
Avoid contact with the blade. Failure to avoid contact
can result in serious personal injury.
 Remove the bag with screws from the grass deflector.
 Fit the grass deflector onto the trimmer head.
 Line up the screw holes in the grass deflector with the
holes in the trimmer head.
 Install supplied screws and tighten by turning clockwise
with a Phillips screwdriver.
WARNING:
Never use blades, flailing devices, wire, or rope on this
product. Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
6 – English