Gas Requirements - GE GTUN275GMWW Instrucciones De Instalación

Minimum Clearance Other Than Alcove or Closet Installation
must
PREPARING FOR INSTALLATION
1
OF NEW APPLIANCE
DISCONNECTING GAS
TURN GAS
DISCONNECT AND DISCARD OLD
SHUT-OFF VALVE
FLEXIBLE GAS CONNECTOR AND
TO THE OFF
OLD TRANSITION DUCTING
POSITION.
MATERIAL. REPLACE WITH NEW
CSA(AGA) APPROVED FLEXIBLE
GAS LINE CONNECTOR AND UL
APPROVED TRANSITION DUCT.
WARNING -
FLEXIBLE CONNECTORS.
REMOVING LINT FROM WALL
EXHAUST OPENING
Remove and discard existing plastic or metal foil
transition duct and replace with UL listed transition duct.
INTERNAL DUCT
OPENING
All manuals and user guides at all-guides.com
Installation Instructions
NEVER REUSE OLD
WALL
CHECK THAT EXHAUST
HOOD DAMPER OPENS
AND CLOSES FREELY.
NEW HOME OR REMODELING FAUCETS/
DRAIN STANDPIPE/ELECTRICAL LOCATION
Locate spigots,
drain standpipe
and electrical plug
in this area

GAS REQUIREMENTS

2
WARNING
ordinances, or in their absence, the NATIONAL
FUEL GAS CODE, ANSI Z223.
Assembly for use only with natural gas. Using
conversion kit WE25M73 for 24" Models or
WE25M74 for 27" Models, your local service
organization can convert this dryer for use with
propane (LP) gas. ALL CONVERSIONS MUST BE
MADE BY PROPERLY TRAINED AND QUALIFIED
PERSONNEL AND IN ACCORDANCE WITH LOCAL
CODES AND ORDINANCE REQUIREMENTS.
The appliance must be disconnected from the gas supply
piping system during any pressure testing of that system
at a test pressure in excess of 0.5 PSI (3.4 KPa).
during any pressure testing of the gas supply piping
27" GAS SUPPLY CONNECTION
Note: 24" Gas supply connection has a exible
hose thus dimensions will vary.
Right side of
Laundry Center
12"
42"
33"
FLOOR