Uline H-6575 Guia De Inicio Rapido página 2

4. Loosely attach the seat to the support arms with 8
of the 3½" lag screws and 8 washers through the
pre-drilled holes using the power drill and 7/16" socket
bit (will tighten later in step 11). (See Figure 3)
NOTE: The two slightly shorter seats should be
attached to the same support arm.
Figure 3
5. Position the seat assembly approximately 10-15" off
the floor. A five gallon bucket under the center works
well. (See Figure 4)
Figure 4
6. Twist center supports of base and half base so they
are flush with bottom boards. Insert 3" drywall screw
into pre-drilled hole through bottom board.
(See Figure 5)
Figure 5
Half Base
7. Insert the three bases under each set of seats.
Center each leg to the counter-bored holes in the
seat. The full base goes under the support arm with
2 seats. (See Figure 6)
Figure 6
PAGE 2 OF 6
ASSEMBLY CONTINUED
8. Use the 2½" lag screws to loosely attach bases to
the seats (will tighten later in step 11). Use a tape
measure to ensure that seats are centered and
2" from base. Make sure the seats are pressed flat
against the base. (See Figure 7)
Figure 7
9. Place the tabletop on top of table to align with the
holes of the bases. Make sure the support arms are
centered. (See Figure 8)
Figure 8
10. Loosely attach each base to the tabletop and
support arms using the 3½" lag screws and washers
with the power drill and 7/16" socket bit (will tighten
later in step 11).
11. Make sure the table is squared and tighten all lag
and drywall screws.
Full Base
1-800-295-5510
uline.com
Centered
Support
Arms
WARNING! Do not lean on tabletop or seats
when assembling.
NOTE: H-6681 Mounting hardware sold
separately.
0721 IH-6575