YABER YR900 Manual Del Usuario página 10

3.Correctly clip the red and black clamps to the
electrodes of the car battery (red to positive and
black to negative)(The green light stays on or the
green and red lights flash alternately)
4.Start the vehicle.
a: If you failed to start your car, you need to
disconnect the battery clamp from the vehicle
and the jump starter.
Wait for at least 30 seconds, then try again.If you
failed to start your car after 2 attempts, you can
use the force start function.
b(optional): Force start function. First please
make sure that the clamps are connected to the
correct polarity battery terminal. Then, press and
hold the force start button for 3 seconds.
When the indicator light of the smart clamp is
solid green, you need to start the vehicle within
30s.
5.When the vehicle is started, remove the
jumper cable from the vehicle battery
immedi- ately.
In any of the following situations, the smart clamp turns on protection
mode:
LED Indicator
The red/green led will flash
The green light is always on
Ready to work
Work status
EN 06
support@ibuture.com
support@yaberauto.com
Situations