Trouble Shooting; Technical Service - Remington BH1822A Manual Del Propietário

All manuals and user guides at all-guides.com
You may have further questions about assem-
bling, operating, or maintaining this product.
If so, you can visit our Technical Service web
site at www.remingtonpowertools.com or
contact our Technical Service Department
at 1-800-626-2237 (English Only). You may
also write to:
DESA Power Tools
ATTN: Technical Service
P.O. Box 90004
Bowling Green, KY 42102-9004
WARNING: Remove battery from the trimmer before servicing.
Severe injury or death could occur from fire, electrical shock, or
body contact with moving blades.
Note: For additional help, visit our technical service web site at www.remingtonpowertools.com.
OBSERVED FAULT
Trimmer does not start
when you squeeze the
trigger.
Trimmer runs slowly or
stalls easily.
Battery discharges
quickly.
Battery not charging.
12

TECHNICAL SERVICE

When contacting DESA Power Tools, have
ready:
• Your name
• Your address
• Your phone number
• Model number of product
• Date of purchase (Include copy of receipt
Always specify model and serial numbers
when writing the factory.
We reserve the right to amend these specifi-
cations at any time without notice. The only
warranty applicable is our standard written
warranty. We make no other warranty, ex-
pressed or implied.

TROUBLE SHOOTING

POSSIBLE CAUSE
1. Battery not installed
properly.
2. Battery not charged.
3. Trigger lockout not de-
pressed prior to squeez-
ing trigger.
1. Battery is nearly depleted.
1. Battery not fully charged.
2. Battery worn and will not
hold charge.
1. Charger not plugged in.
2. Battery not fully inserted
into charger base.
3. Charger cord not properly
connected.
4. Charger damaged.
SAVE THESE INSTRUCTIONS
www.remingtonpowertools.com
for written requests).
REMEDY
1. Verify proper installation of
battery.
2. Insure battery is charged per
requirements.
3. Follow directions outlined in
basic trimmer operation.
1. Recharge battery completely.
1. Recharge battery completely.
2. Replace battery.
1. Plug charger into 120V 60Hz
AC source.
2. Insure battery is inserted cor-
rectly into charger base.
3. Insure charger cord is fully
inserted into charger base.
4. Replace charger.
122044-01B