Warnings - Safety Instructions; General Instructions; Required Equipment - Toparc RC-PLASMA Manual Del Usuario

WARNINGS - SAFETY INSTRUCTIONS

GENERAL INSTRUCTIONS

These instructions must be read and understood before using the device.
Do not carry out any modification or maintenance not specified in the manual.
The manufacturer will not be held responsible for any damage to persons or property caused by failure to use this product in accordance with the
manual's instructions. In case of problems or queries, please consult a qualified tradesperson to correctly install the product.
This manual describes the wiring of this product. Failure to strictly adhere to the safety instructions described in this manual may lead to the risk of
electrical hazards and/or serious injury or death.
ELECTRICAL SAFETY
When working with this product, ensure that the area is safe and that no one unfamiliar with the safety instructions in this manual is allowed to enter.
This product should preferably be installed by a professional in accordance with your country's current installation rules. If this is not possible, it is
recommended that you read these rules carefully before working on the product.
SAFETY PRECAUTIONS
The RC-PLASMA remote control requires the installation of a connection cable inside the product. For this reason, installation should be carried out
by a qualified person.
Before working on the plasma power source, it is essential to disconnect it from the mains and to wait five minutes before accessing the
interior of the plasma power source.
INSTALLATION - PRODUCT FEATURES
Only experienced personnel, authorised by the manufacturer, may carry out the product's installation. During installation, ensure
that the power source is disconnected from the mains.
INTRODUCTION
The RC-PLASMA remote control allows the plasma arc to be triggered manually and remotely using automated settings (using a trigger-less straight
torch).
The RC-PLASMA remote control is compatible with the following plasma cutters:
- CUTTER 45 CT / 70 CT
- NEOCUT 105 / 125

REQUIRED EQUIPMENT

Torx 20 Allen key n°2
®
6
RC-PLASMA
N°5.5
EN