All manuals and user guides at all-guides.com
NOTE: Nozzles are color coded to
match colored nozzles on panel.
7.
Place the nozzle holder onto
the panel (located on the handle
assembly) and push each nozzle
holder into place.
NOTE: The high pressure pump was
filled with oil at the factory. The oil in
the high pressure pump was designed
to last the life of the pump. If there is
a problem with the pump contact an
Authorized Service Center.
The shipping plug
must be removed
and replaced with the dipstick/oil
plug before operating pressure
washer.
8.
Using an 11/16"
wrench, remove
shipping plug
from pump
by turning it
counterclockwise. Discard plug.
9.
Remove dipstick/oil plug from
plastic bag and install into pump,
tighten securely.
gauge to check the tires pressure
before each use and while inflating
tires; see the tire sidewall for the
correct tire pressure.
NOTE: Air tanks, compressors and similar
equipment used to inflate tires can fill
small tires similar to these very rapidly.
Adjust pressure regulator on air supply
to no more than the rating of the tire
pressure. Add air in small increments
and frequently use the tire gauge to
prevent over inflation.
9 - ENG
Risk of bursting.
Use a tire pressure
A16091