Adjusting Loudness; Using Subwoofer Output; Adjusting Subwoofer Settings; Using The High Pass Filter - Pioneer DEH-P65BT Manual De Operación

Section
Operating this unit
02
3 Push MULTI-CONTROL up or down to
select the desired Q factor.
Each time MULTI-CONTROL is pushed up or
down, Q factor is selected in the following
order:
2N—1N—1W—2W
Note
If you make adjustments, CUSTOM curve is up-
dated.

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Use MULTI-CONTROL to select
LOUDNESS.
2 Press MULTI-CONTROL to turn loudness
on.
Loudness level (e.g., MID) appears in the dis-
play.
# To turn loudness off, press MULTI-CONTROL
again.
3 Push MULTI-CONTROL left or right to
select a desired level.
Each time MULTI-CONTROL is pushed left or
right, level is selected in the following order:
LOW (low)—MID (mid)—HIGH (high)

Using subwoofer output

This unit is equipped with a subwoofer output
which can be turned on or off.
1 Use MULTI-CONTROL to select SUB W1.
2 Press MULTI-CONTROL to turn subwoo-
fer output on.
NORMAL appears in the display. Subwoofer
output is now on.
# To turn subwoofer output off, press
MULTI-CONTROL again.
36
En
All manuals and user guides at all-guides.com
3 Push MULTI-CONTROL left or right to
select the phase of subwoofer output.
Push MULTI-CONTROL left to select reverse
phase and REVERSE appears in the display.
Push MULTI-CONTROL right to select normal
phase and NORMAL appears in the display.

Adjusting subwoofer settings

When the subwoofer output is on, you can ad-
just the cut-off frequency and the output level
of the subwoofer.
1 Use MULTI-CONTROL to select SUB W2.
# When the subwoofer output is on, you can se-
lect SUB W2.
2 Push MULTI-CONTROL left or right to
select cut-off frequency.
Each time MULTI-CONTROL is pushed left or
right, cut-off frequencies are selected in the
following order:
50Hz—63Hz—80Hz—100Hz—125Hz
Only frequencies lower than those in the se-
lected range are outputted from the subwoo-
fer.
3 Push MULTI-CONTROL up or down to
adjust the output level of the subwoofer.
Each time MULTI-CONTROL is pushed up or
down, subwoofer level increases or decreases.
+6 to –24 is displayed as the level is increased
or decreased.

Using the high pass filter

When you do not want low sounds from the
subwoofer output frequency range to play
from the front or rear speakers, turn on the
HPF (high pass filter). Only frequencies higher
than those in the selected range are outputted
from the front or rear speakers.
1 Use MULTI-CONTROL to select HPF.
2 Press MULTI-CONTROL to turn high
pass filter on.
80Hz appears in the display. High pass filter is
now on.