Black and Decker GPC1800 Manual Del Usuario página 7

Warning symbols
The following warning symbols are found on the tool:
Read the instruction manual before use.
Do not use the tool in wet conditions or expose it to
rain.
Always wear head and eye protection.
Wear non-slip safety footwear.
Beware of falling objects. Keep bystanders away.
Electrocution hazard. Keep at least 10 m away from
overhead lines.
To ensure continued safe operation, check the chain
tension as described in this manual after every
10 minutes of use, and adjust back to a clearance of
3 mm as required. Oil the chain after every
10 minutes of use.
Direction of rotation of the chain.
Additional safety instructions for batteries and chargers
Batteries
Never attempt to open for any reason.
x
Do not expose the battery to water.
x
Do not store in locations where the temperature may
x
exceed 40 °C.
Charge only at ambient temperatures between 4 °C and
x
40 °C.
Charge only using the charger provided with the tool.
x
When disposing of batteries, follow the instructions given
x
in the section "Protecting the environment".
Under extreme conditions, battery leakage may occur.
x
When you notice liquid on the battery, proceed as follows:
- Carefully wipe the liquid off using a cloth.
Avoid skin contact.
- In case of skin or eye contact, follow the instructions
below.
Warning! The battery fluid, a 25-30% solution of potassium
hydroxide, can be harmful. In case of skin contact,
immediately rinse with water.
All manuals and user guides at all-guides.com
Neutralise with a mild acid such as lemon juice or vinegar.
In case of eye contact, rinse abundantly with clean water for
at least 10 minutes. Consult a physician.
Do not incinerate the battery.
x
Do not attempt to charge damaged batteries.
x
Chargers
Use your Black & Decker charger only to charge the
x
battery in the tool with which it was supplied. Other
batteries could burst, causing personal injury and damage.
Never attempt to charge non-rechargeable batteries.
x
Have defective cords replaced immediately.
x
Do not expose the charger to water.
x
Do not open the charger.
x
Do not probe the charger.
x
The charger is intended for indoor use only.
Overview
1. On/off switch
2. Lock-off button
3. Main handle
4. Saw head
5. Sprocket cover
6. Guide bar
7. Chain
8. Chain sheath
9. Lubrication bottle
10. Extension tube
11. Battery
Fig. A
12. Charger
13. Charging indicator
14. End of charge indicator
Assembly
Warning! Before assembly, remove the battery from the tool.
Fitting and removing the battery (fig. B)
To fit the battery (11), line it up with the receptacle on the
x
tool. Slide the battery into the receptacle and push until
the battery snaps into place.
To remove the battery, push the release button (15) while
x
at the same time pulling the battery out of the receptacle.
Warning! To prevent accidental operation, ensure that the
battery is removed and that the chain sheath is in place on the
saw chain before performing the following operations.
Failure to do this could result in serious personal injury.
ENGLISH
7