Replacing Fuse - Trust UPS Serie Manual Del Usuario

User's manual
Product Information
A: On/Off button
B: Status LED
- AC power: Lit steady
- Battery power: Lit flash
Installation
1
PC off
Use power cable from PC to connect UPS to AC socket
2
Use loop through cable (H) to connect PC to UPS Backup output (G)
UPS least 20cm away from monitor!
UPS on
3
The UPS might be battery low due to its self-discharge characteristic; suggest to charge 8 hours
before using battery power!
4
PC on

Replacing fuse

1
UPS completely off, (disconnect mains power)
2
Use fuse of same rating (250V, 5A)!
Open fuse holder
Replace a proper fuse at position F
Reminder
UPS is charged only when AC power is supplied and UPS is on!
Fully discharge then recharge the battery every 3 months for longer battery life!
Connect incoming analogue phone line to D; Connect a telephone or modem to C!
Backup time is related to the connected devices and battery condition!
UPS does not have dial-up function nor smart management like message alarm!
C: Phone/Modem out G: Output
D: Phone line in H: Loop through cables
E: AC input
F: Fuse holder
1