Toya 72928 Manual Del Usuario página 9

GB
NOTE! It is prohibited to work with a vacuum cleaner without properly mounted air fi lter. This can lead to damage of the vacuum
cleaner and electric shock.
Filter should be mounted to the underside of the cover so as it evenly adheres (II). The seal, which is integral with the top edge of
the fi lter, has a fl ange which enables reliable anchorage of the fi lter.
Mount the cover on the upper edge of the tank of vacuum cleaner so it adheres by its entire circumference. Using clips push the
lid into the tank. Pay attention to the fact that on the cover there are two designated place, which allow you to obtain the best
sealing of this connection (III).
Connect elastic hose to the inlet. The hose connection must be inserted in the hole, so that the notches on it match the protrusions
of the inlet, and then turn it in the direction of the arrow with inscription "CLOSE" (IV). Make sure that the hose cannot slip out of
the hole during operation.
Connect the suction nozzle to the free end of the hose by inserting it into the hose connector (IV).
In order to dismantle the interior, turn its connection in the direction of the arrow described with inscription "OPEN" and then pull
out connector from the inlet.
Vacuum cleaner also allows for hose connection to the outlet, which make possible to use it as a blower. The hose is connected
in the same manner as in the case of the inlet. Because this connection is not marked by arrows, with mounting and dismounting
you should follow the arrows at the inlet.
Operation of the vacuum cleaner
NOTE! It is prohibited to work with a vacuum cleaner with hot ash. Temperature of the sucked waste by the vacuum cleaner may
not exceed 40 °C.
Make sure that all the preparatory activities have been properly performed.
Make sure the vacuum switch is on the off position "O" (V).
Plug the power cord into the mains socket, and then set the switch on position "I".
After fi nishing work switch off the vacuum cleaner and then unplug the power cord from the wall socket. Proceed to the mainte-
nance activities for vacuum cleaner.
Note! If during the operation there will be observed suspicious vibration, drop in suction, or you will hear the louder engine opera-
tion, it may mean the fi lling of tank or clog of hose or suction nozzle. In this case, immediately turn off the vacuum cleaner by the
switch and unplug the power cord from the mains socket. Then empty the tank and check for obstruction in the hose and nozzle. If
necessary unblock. if unblocking the hose or suction nozzle is not be possible, they must be replaced before further work.
Note! If you use a vacuum cleaner as a blower, make sure that the tank has been emptied of all debris, and the fi lter cleaned or
replaced. There is a risk of suction of impurities accumulated in the reservoir through the inlet.
Maintenance of the vacuum cleaner
Note! Before any maintenance activities, make sure that the power cord is disconnected from the mains socket.
After each use of a vacuum cleaner, check the tank lid seal, and air fi lter as it is described in the Section: "Preparing for opera-
tion".
Clean the vacuum from the outside with a jet of compressed air, of pressure of not more than 0.3 MPa. Particular attention should
be paid to the patency of the ventilation holes, both inlet and exhaust. If needed, clean it by compressed air of pressure not more
than 0.3 MPa. Do not use sharp metal objects to clean the vents. Do not immerse the cleaner in water to vacuum clean it. Vacuum
cleaner hose must be checked before and after each use for damage. It is forbidden to use a damaged hose.
Larger dirt from the housing should be removed with a soft cloth.
O R I G I N A L I N S T R U C T I O N S
9