Technoline WL 1025 Manual Del Usuario página 19

Notes

The CO2 sensor will be initialized for about 60 seconds
and then the CO2 values and displays will be updated and
shown.

Place the WL 1025 securely on a flat surface with enough
free space on all sides. This way, the CO2 sensor and the
thermo-hygro sensor within the WL 1025 can get the best
results.

It is recommended to use DC power supply for a long time,
and try not to use the built-in lithium battery to low power.
Time and alarm time setting

In normal display mode, hold the "
seconds to enter the setting mode.

Press the "+" or the "-" button to adjust the setting and
press the "
or the "-" button pressed, to accelerate the process and
reach the desired value more quickly.

The setting sequence is shown as follows: 12/24 hour
display -> hour -> minute -> alarm time hour -> alarm time
minute -> °C/°F temperature unit -> exit
Note:

The setting will automatically exit after 30 seconds without
" button to confirm each setting. Keep the "+"
EN4
" button for 3