Kinderkraft RAPID Manual De Usuario página 13

II Assembly of the bike
Start to assemble the bike from screwing the front fork (B) with the front wheel (C) using screws and washers (E&F)
and mounting keys (K) (Fig. 1). Note: The "drive" mark on the wheel should be set in the right direction. Slide the
obtained element in frame (A). Note the correct installation of handlebar limiter (Fig. 2). Then put the metal ring
(I) and handlebar (D) on the top part of the fork previously loosening screws of the handlebar in order to facilitate
the fitting (Fig. 3). Once the handlebar is slid on the upper part of the fork, tighten the screws again. Note! The
handlebar must be tightened to the maximum. Secure he opening in the handlebar from the top with a screw and
the overlay (G&H) (Fig. 4). Note! Tighten the screw (G) in such a way as to be able to freely move the handlebar
while leaving clearance between the bolt and cap. Remove the screw from the bell (J). Place the bell on the
handlebar and tighten it with a mounting screw. You can adjust the height of the seat using the screw located at
the tube. Remember that the minimum bracket slide mark must be fully hidden in the frame (slide the seat in such
a way so that the arrow on the support is inside the tube) (Fig. 5). NOTE! Before each use check if all the connecting
elements (screw, nuts) are well-adjusted. Small parts must be kept out of the reach of children.
III Maintenance and cleaning, storage
Clean the product with a damp cloth or sponge. Protect from dust, moisture, water, high and very low
temperatures, falls, etc.
IV Warranty
1. All Kinderkraft products are covered by a 24-month warranty. The warranty period begins on the date of
releasing the product to the Buyer.
2. The warranty is valid for products sold in the following countries: France, Spain, Germany, Poland, United
Kingdom, Italy.
3. In countries not listed above warranty terms and conditions are determined by the Seller.
4. It is possible to extend the warranty period to 120 months (10 years). Full text of the terms and conditions
and warranty extension registration form are available at
5. The warranty is valid only in the country where the purchase was made.
6. Complaints should be submitted by completing the form available at
7. The warranty shall not cover:
a. claims arising from product specifications, as long as they comply with those specified by the manufacturer in
the instruction manual or other documents of a legislative nature;
b. product damage caused by improper maintenance or use of inadequate chemicals;
c. colour change (discolouration) when the product has been exposed to direct sunlight against the instructions
provided in the instruction manual;
d. tear, wear, crack of fabric/plastic that is the fault of the Customer;
e. reduction in the quality of the product and consumables due to normal wear and tear;
f. products which have not been used according to specifications;
8. The warranty period for accessories attached to the device is 6 months from the date of sale, with the
exception of mechanical damage.
9. These guarantee terms and conditions are complementary to the Customer's rights in relation to 4KRAFT sp.
z o.o. The warranty shall not exclude, limit or suspend the rights of the Customer arising from the provisions
on the warranty for defects in the goods sold.
10. Full text of Warranty Terms and Conditions is available at
All rights to the present document belong entirely to 4Kraft Sp. z o.o. Any unauthorized use of them against
their purpose, including in particular: using, copying, reproducing, making available - in whole or in part,
without the consent of 4Kraft Sp. z o.o. may result in legal consequences.
WWW.KINDERKRAFT.COM
WWW.RMA.KINDERKRAFT.COM
WWW.KINDERKRAFT.COM
13