Connecting The Product; Declaration Of Conformity - nedis WIFILR001BK Guia De Inicio Rapido

• Observe the plus (+) and minus (–) marks on the cell, battery
and equipment and ensure correct use.
• Dispose of the cell or battery properly.
• Seek medical advice immediately if a cell or a battery has
been swallowed.
Placing the batteries
-
Use only size AAA batteries (not included) for this product.
-
Observe the plus (+) and minus (–) marks on the cell,
battery and equipment and ensure correct use.
1. Open the battery compartment A
2. Place the batteries.
3. Close A
.
6

Connecting the product

1. Switch the lamp off and on once to activate pairing mode.
Perform the following step within 20 seconds.
4
2. Press and hold the on button A
indicator LED A
The lamp blinks three times when the product has been
4
connected successfully.
Repeat the steps to connect the product to multiple lamps.
Disconnecting the product
1. Press and hold the off button A
disconnect the lamps from the product.

Declaration of Conformity

We, Nedis B.V. declare as manufacturer that the product
WIFILR001BK from our brand Nedis
has been tested according to all relevant CE standards and
regulations and that all tests have been passed successfully.
This includes, but is not limited to the RED 2014/53/EU
regulation.
The complete Declaration of Conformity (and the safety
datasheet if applicable) can be found and downloaded via:
nedis.com/WIFILR001BK#support
For additional information regarding the compliance, contact
the customer service:
Web: www.nedis.com
E-mail: service@nedis.com
Nedis B.V., de Tweeling 28
5215 MC 's-Hertogenbosch, the Netherlands
1 starts blinking.
5
6 .
2 for 10 seconds until the
for 10 seconds to
4
, produced in China,
®