Top Cover
Top Tube
Plastic
Lens
Set Screw
Ground
Square
Side Bars
Bottom Cover
Nut for ground
installation
Lock Nut
HINKLEY LIGHTING
33000 Pin Oak Parkway
Glass Clips
Glass
Threaded Tube
Assembly
Bollard Mount
PVC
Glass
Glass
Holders
Nut
Bottom Plate
Wiring Coupler
Threaded Tube
Avon Lake, OH 44012
Installation Instructions
Family: Shelter | Item No. 15607
Start Here
Unpacking
1. Unpack the bollard and the glass from the box.
2. Remove the bollard mount, threaded tube assembly, and PVC
pipe from the box.
Luminaire Mounting
Note: If your local code requires a frost line burial deeper than
12 inches, you may purchase a 2 inch PVC pipe (sch. 40 or sch.
80) from a local supplier and cut to length as a replacement to
the provided PVC pipe.
1. Dig a hole about 12 inches or deeper, depending on your local
code.
2. Feed the wires through the PVC pipe and insert it in the ground,
make sure the PVC is sticking out of the ground enough that
the bollard mount will t on top of the PVC, and that the bottom
of the bollard mount is level with the ground.
3. Fill in the hole around the PVC pipe.
4. Level the PVC pipe with a post level.
5. Feed the wires through the bollard mount and the threaded
tube assembly, pull the wires out through the wiring coupler.
6. Put the bollard mount on top of the PVC pipe.
7. Tighten the three set screws on the sides of the bollard mount.
Note: You may set the PVC in cast concrete. It is suggested using
a longer PVC pipe and conduit, that is not provided.
Cut the PVC to height after the concrete is set.
Assembly
1. Connect the xture wires and the main wires together using
wire nuts. Put the silicone glue, that's provided, in the wire nuts
to waterproof.
2. Unscrew the two screws from the top cover and remove the
cover. Let the cover hang over the edge of the xture.
3. Pull apart the 2 square side bars to release the top tube. While
pulling the side bars, take o the top tube. It will hang o to
the side. Pull out the plastic lens and set aside.
4. For ground installation: screw the nut (supplied) onto the
threaded tube to get the correct height adjustment. This step
is not needed for concrete or other hard surface installations.
5. Put the main body of the xture over the bollard mount and
threaded tube assembly.
6. Rotate the xture to the desired position.
7. Put a nut (supplied in the parts bag) on top of the threaded
tube and tighten.
8. Place the bottom cover on top of the glass holders and then
slide the glass into the holders. Place the plastic lens around
the glass.
9. Put the top tube back on by pulling apart the square side bars.
Screw in the glass clips from the parts bag.
10. Insert the bulb. (If applicable)
11. Put the top cover back on and tighten the two screws.
(p)800.442.5539 / (f ) 440.653.5555
www.hinkleylighting.com