Nemaxx GVF120 Manual Del Usuario página 3

SCOPE OF DELIVERY ( incl. 1 x glass sheet in the desired size )
Item name
A. Tension rods (1 m)
B. Point holders with joints
( point supports with
clamping plates )
C. Point holders with joints
( glass mountings )
D. Wall brackets
E. Screws M8x30
F. Steel sleeves M8
G. Set hex keys
INSTALLATION
120 x 90 200 x 90
160 x 90 250 x 90
180 x 90
2x 3x
2x 3x
2x 3x
2x 3x
4x 6x
4x 6x
1x 1x
!
50
10
EN
A
300 x 90
4x
B
4x
4x
4x
8x
8x
1x
Planning
Determine the height and the angle of the canopy.
You can choose an angle between 80 and 85 degrees.
The distance between the upper and the lower drilling holes
determine the inclination of the canopy.
The lower the distance, the steeper the angle will be.
The distance may vary from 76 to 80 cm.
Marking the drilling holes
Find the centre of the entrance and mark it.
Draw a line using the level.
Hold the two supports at the correct width to the wall (on the
line) and mark the drilling holes.
After that place marks for the upper holes in accordance with
the desired inclination from 76 to 80 cm above the lower
holes.
It is recommended to use a plumb line.
Drilling
Drill the marked holes.
Use a concrete/stone drill with a diameter of 10 mm and
a lenght of 50 mm.
Make sure you drill straight holes.
3
C
G
E
F
D
v02 • 08.08.2017