Cleaning And Maintenance; Conditions Of Warranty - Qlima FFW 3052 Instrucciones De Uso

Put some fire lighter as mentioned under A, B or C above into the decorative fire
place
Light the fire lighter (A, B or C) with a long match or a gas fire lighter.
When the fire is lit: put on some more dry wood in the fire place.
WARNING! to prevent the risk on too high fire and to prevent the risk to create
an unstable fire place: never fill the fire place over 50% of its volume and never
have wood sticking out of the top or sides.

CLEANING AND MAINTENANCE

Your product is made of high-quality materials. To clean and maintain the surfa-
ces, please heed the following instructions:
DANGER: RISK OF BURNING!
Let the appliance cool down completely before cleaning it.
Only tip out the ash when the fuel has completely burned out.
ATTENTION: RISK OF DAMAGE!
Do not use any strong or grinding solvents or abrasive pads, since these can attack
the surfaces and leave behind scrape marks.
• Let the fuel burn out completely after use.
• Empty out the cold ash. It is very important that you remove the ash before
moisture combines with the cold ash. Ash is saline and, in a moist condition,
will attack the inside of the ash collecting tray. Thus, over years the ash col-
lecting tray can sustain damage through rust.
• Clean the product, internally and externally regularly with soapy water, at
best after every use.
• Use a soft, clean cloth for drying. Do not scratch the surfaces when wiping
them dry.
• Tighten all screws before every use to guarantee stable footing.
• Protect your product against continuous weather influences. Since it is manu-
factured from steel it will eventually rust. Clean possible rust spots and repair
them with fireproof paint.
• IMPORTANT: The product should always be stored somewhere where it is
protected from moisture.

CONDITIONS OF WARRANTY

There is a two-year warranty on your product from the date of purchase. All
material or manufacturing defects will be repaired free of charge.
The following applies:
• All claims for compensation, including consequential damage, will not be
entertained.
• Any repairs or replacement of components during the warranty period will
not result in an extension of the warranty period.
• The warranty will expire if any alterations have been made, not genuine com-
ponents have been fitted or have been repaired by a third party.
• Components subject to normal wear and tear are not covered by the war-
ranty.
4
25