Important - Evenflo exersaucer BABY ACTIVE Manual Del Usuario

Assembling the ExerSaucer
H
H
I
E
E > !
6. Place Seat Ring upside down and locate the wheel holders
E
Click six (6) Seat Wheels into wheel holders, as shown.
F
G
E > @
E
7. Turn Seat Ring right side up. Align triangles
E
with the triangles G > ! on the seat pad label. Snap the plastic tabs
pad over the pegs on the Seat Ring. Continue this process until all tabs are
E > #
attached to all pegs.
All manuals and user guides at all-guides.com
4. After all four Legs are locked in place,
turn the ExerSaucer right-side-up.
5. Place Base H on Legs A
ExerSaucer. Make sure the Base is
resting in the notches on the Legs, as
shown. Then place the Base Cap
the center of the Base.
A
IMPORTANT: Base MUST be in
H
place before using Stage 1.
Base Cap MUST be placed in the
I
Base with the rim facing down, as
shown.
F
CLICK!
.
E > !
G > !
CLICK!
on the back of the Seat Ring
E > @
G > @
4
E > $
D > !
under the
CLICK!
in
I
G > @
C > !
E > #
During use, allow the baby's toes only to touch the Base. DO NOT allow
the baby to stand flat-footed on the Base. As baby grows and becomes
on the
more active, raise the Tray to the next level so that baby enjoys the most
comfortable fit and maximum use of the spin, and bounce features.
Assembling the ExerSaucer
8. Press assembled
Seat Ring
E > $
down firmly onto
the Bounce Ring
until it clicks
D > !
into place and
spins freely.
To adjust height:
ALWAYS remove baby from ExerSaucer before
adjusting.
Squeeze tabs while unscrewing Hand Lock
C > !
Unscrew only far enough to free the Hand Lock
from the opening in the Tray. Move the Tray
up or down to the desired height, then tighten
the Hand Lock until it locks in place. DO NOT
OVERTIGHTEN.
IMPORTANT: When inserting Hand Locks, use
the same opening in each Leg Assembly, or the
ExerSaucer will not be level.
Loosen Tighten
WARNING
5
.
C