SOMFY Weather Station M8 Guia De Instalacion página 10

EN
Before installation, please read and follow these instructions. Incorrect installation may lead to serious injury.
Disconnect all power cables to be installed! Take precautions against unintentional switching on! The product
must be installed, maintained and dismounted by a skilled person according to the relevant regulation. An all-
pole mains switch shall be incorporated in the electrical installation of the building to provide simultaneous
separation of at least 3 mm for all phases from the supply.
Somfy cannot accept any liability for defects and damage caused by failure to follow these instructions. Please
keep these instructions for future reference.
Somfy hereby declares that the radio equipment covered by these instructions is in compliance with the re-
quirements of Radio Directive 2014/53/EU and other essential requirements of the applicable European Direc-
tives. The full text of the EU declaration of conformity is available at www.somfy.com/ce.
Radio frequency
Frequency bands and maximum power used
Somfy limited, Yeadon LS19 7ZA UK, hereby declares that the radio equipment covered by these instructions
is in compliance with the requirements of UK legislation: the Radio Equipment Regulations S.I. 2017 N°1206.
The full text of the UKCA declaration of conformity is available at www. somfy.co.uk
A
MOUNTING
For exact determination of wind and bright-
ness direction the Weather Station must be
mounted in north alignment (N).
The place where the sensor is installed might
have an impact on the measured values.
[1] Façade mounted version
[2] Roof mounted version
1. Mounting with Somfy accessories (1) – (3) on
a mast Ø 50 mm
2. Mounting on already existing mast Ø 25 mm
3. Mounting on already existing mast Ø 50 mm
with Bracket for Weather Station (4)
[3]
The weather station must always be installed
upright, not horizontal or in an angle
As the device works without moving parts, i.e. wear-free, only a minimum of service work is required.
Depending on the location, the device may become dirty. The device should be cleaned with water and a soft
cloth.
During storage, assembly, disassembly, transport or maintenance of the Weather Station, ensure
that no water enters the unit or plug.
10/32 -
animeo IB+/IP/KNX Weather Station M8/Weather Station M13 Ref. 5146655D
868-870 MHz io-homecontrol®, two-way, tri-band
868.000 MHz – 868.600 MHz e.r.p. <25 mW
868.700 MHz – 869.200 MHz e.r.p. <25 mW
869.700 MHz – 870.000 MHz e.r.p. <25 mW
B
WIRING
Use rigid cable.
If a hole has been drilled in the mast during in-
stallation of the unit to fit the cable through,
the cable may be damaged by sharp edges.
The cable for connection of the weather sta-
tion must be suitable for permanent ourdoor
use and compliant to the relevant standards.
Powered/no communication:
Powered/communication:
C
TOPOLOGY
A. "xx" represents the bus system handled by the
gateway, e.g. io, SDN, ...