Assembly And Adjustment - DeWalt DW292 Manual Del Usuario

Using an extension cable
If an extension cable is required, use an approved
extension cable suitable for the power input of this
tool (see technical data). The minimum conductor size
2
is 1.5 mm . When using a cable reel, always unwind
the cable completely. Also refer to the table below.
2
Conductor size (mm ) Cable rating (Amperes)
0.75 6
1.00 10
1.50 15
2.50 20
4.00 25
Cable length (m)
7.5
Voltage Amperes Cable rating (Amperes)
115 0 - 2.0 6
2.1 - 3.4 6
3.5 - 5.0 6
5.1 - 7.0 10
7.1 - 12.0 15
12.1 - 20.0 20
230 0 - 2.0 6
2.1 - 3.4 6
3.5 - 5.0 6
5.1 - 7.0 10
7.1 - 12.0 15
12.1 - 20.0 20

Assembly and adjustment

Prior to assembly and adjustment always
unplug the tool.
Fitting and removing sockets
Your DW292 impact wrench uses a 1/2" square
drive system with detent pin.
Your DW294 impact wrench uses a 3/4" square
drive system with detent pin.
Fitting sockets (fig. B)
• Align the hole (6) in the side of the socket with
the detent pin (5) on the anvil.
• Push the socket (4) onto the anvil (3) until it snaps
into place. Tap it lightly if required.
All manuals and user guides at all-guides.com
15 25 30 45 60
6 6 6 6 10
6 6 6 15 15
6 10 15 20 20
10 15 20 20 25
15 20 25 25 -
20 25 - - -
6 6 6 6 6
6 6 6 6 6
6 6 6 10 15
10 10 10 15 15
15 15 15 20 20
20 20 20 25 -
Removing sockets (fig. C)
• Depress the detent pin (5) through the hole (6) in
the socket and pull the socket off the anvil.
Setting the direction of rotation (fig. D)
• Select forward or reverse rotation using the
forward/reverse switch (2).
Always wait until the motor has come to
a complete standstill before changing the
direction of rotation.
Instructions for use
Always observe the safety instructions
and applicable regulations.
Screwdriving or nutsetting (fig. A)
• Select the appropriate socket for the screw or
nut to be driven.
• Select forward or reverse rotation as described
above.
• Hold the tool in line with the fastener.
Switching ON and OFF (fig. A)
• To run the tool, press the ON/OFF-switch (1).
• To stop the tool, release the switch.
Various types of sockets, holders and adaptors are
available as an option. Consult your dealer for further
information on the appropriate accessories.
Maintenance
Your D WALT Power Tool has been designed to
E
operate over a long period of time with a minimum
of maintenance. Continuous satisfactory operation
depends upon proper tool care and regular cleaning.
Lubrication
Your Power Tool requires no additional lubrication.
Cleaning
Keep the ventilation slots clear and regularly clean
the housing with a soft cloth.
E N G L I S H
19